xref: /netbsd-src/sys/dev/ic/rf3000reg.h (revision 4b896b232495b7a9b8b94a1cf1e21873296d53b8)
1 /* $NetBSD */
2 
3 /*
4  * Copyright (c) 2005 David Young.  All rights reserved.
5  *
6  * This code was written by David Young.
7  *
8  * Redistribution and use in source and binary forms, with or without
9  * modification, are permitted provided that the following conditions
10  * are met:
11  * 1. Redistributions of source code must retain the above copyright
12  *    notice, this list of conditions and the following disclaimer.
13  * 2. Redistributions in binary form must reproduce the above copyright
14  *    notice, this list of conditions and the following disclaimer in the
15  *    documentation and/or other materials provided with the distribution.
16  * 3. Neither the name of the author nor the names of any co-contributors
17  *    may be used to endorse or promote products derived from this software
18  *    without specific prior written permission.
19  *
20  * THIS SOFTWARE IS PROVIDED BY David Young ``AS IS'' AND ANY
21  * EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO,
22  * THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A
23  * PARTICULAR PURPOSE ARE DISCLAIMED.  IN NO EVENT SHALL David
24  * Young BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL,
25  * EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED
26  * TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE,
27  * DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND
28  * ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY,
29  * OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY
30  * OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY
31  * OF SUCH DAMAGE.
32  */
33 
34 #ifndef _DEV_IC_RF3000REG_H_
35 #define	_DEV_IC_RF3000REG_H_
36 
37 /*
38  * Registers for RF Microdevices RF3000 spread-spectrum baseband modem.
39  */
40 #define RF3000_CTL		0x01		/* modem control */
41 #define RF3000_RXSTAT		RF3000_CTL	/* RX status */
42 #define		RF3000_CTL_MODE_MASK		BITS(7, 4)
43 #define		RF3000_RXSTAT_ACQ		BIT(2)
44 #define		RF3000_RXSTAT_SFD		BIT(1)
45 #define		RF3000_RXSTAT_CRC		BIT(0)
46 #define RF3000_CCACTL		0x02		/* CCA control */
47 /* CCA mode */
48 #define		RF3000_CCACTL_MODE_MASK		BITS(7, 6)
49 #define		RF3000_CCACTL_MODE_RSSIT	0	/* RSSI threshold */
50 #define		RF3000_CCACTL_MODE_ACQ		1	/* acquisition */
51 #define		RF3000_CCACTL_MODE_BOTH		2	/* threshold or acq. */
52 /* RSSI threshold for CCA */
53 #define		RF3000_CCACTL_RSSIT_MASK	BITS(5, 0)
54 #define RF3000_DIVCTL		0x03		/* diversity control */
55 #define		RF3000_DIVCTL_ENABLE		BIT(7)	/* enable diversity */
56 #define		RF3000_DIVCTL_ANTSEL		BIT(6)	/* if ENABLE = 0, set
57 							 * ANT SEL
58 							 */
59 #define RF3000_RSSI		RF3000_DIVCTL	/* RSSI value */
60 #define		RF3000_RSSI_MASK		BITS(5, 0)
61 #define RF3000_GAINCTL		0x11		/* TX variable gain control */
62 #define		RF3000_GAINCTL_TXVGC_MASK	BITS(7, 2)
63 #define		RF3000_GAINCTL_SCRAMBLER	BIT(1)
64 #define	RF3000_LOGAINCAL	0x14		/* low gain calibration */
65 #define		RF3000_LOGAINCAL_CAL_MASK	BITS(5, 0)
66 #define	RF3000_HIGAINCAL	0x15		/* high gain calibration */
67 #define		RF3000_HIGAINCAL_CAL_MASK	BITS(5, 0)
68 #define		RF3000_HIGAINCAL_DSSSPAD	BIT(6)	/* 6dB gain pad for DSSS
69 							 * modes (meaning?)
70 							 */
71 #define RF3000_OPTIONS1		0x1C		/* Options Register 1 */
72 /* Saturation threshold is 4 + offset, where -3 <= offset <= 3.
73  * SAT_THRESH is the absolute value, SAT_THRESH_SIGN is the sign.
74  */
75 #define		RF3000_OPTIONS1_SAT_THRESH_SIGN	BIT(7)
76 #define		RF3000_OPTIONS1_SAT_THRESH	BITS(6,5)
77 #define		RF3000_OPTIONS1_ALTAGC		BIT(4)	/* 1: retrigger AGC
78  							 * algorithm on ADC
79  							 * saturation
80 							 */
81 #define		RF3000_OPTIONS1_ALTBUS		BIT(3)	/* 1: enable alternate
82 							 * Tx/Rx data bus
83 							 * interface.
84 							 */
85 #define		RF3000_OPTIONS1_RESERVED0_MASK	BITS(2,0)/* 0 */
86 
87 #define RF3000_OPTIONS2		0x1D		/* Options Register 2 */
88 /* 1: delay next AGC 2us instead of 1us after a 1->0 LNAGS-pin transition. */
89 #define		RF3000_OPTIONS2_LNAGS_DELAY	BIT(7)
90 #define		RF3000_OPTIONS2_RESERVED0_MASK	BITS(6,3)	/* 0 */
91 /* Threshold for AGC re-trigger. 0: high count, 1: low count. */
92 #define		RF3000_OPTIONS2_RTG_THRESH	BIT(2)
93 #define		RF3000_OPTIONS2_RESERVED1_MASK	BITS(1,0)	/* 0 */
94 
95 #endif /* _DEV_IC_RF3000REG_H_ */
96