xref: /netbsd-src/sys/dev/ic/al2210reg.h (revision 2980e352a13e8f0b545a366830c411e7a542ada8)
1 /* $NetBSD: al2210reg.h,v 1.4 2006/03/08 08:26:50 dyoung Exp $ */
2 
3 /*
4  * Copyright (c) 2004 David Young.  All rights reserved.
5  *
6  * This code was written by David Young.
7  *
8  * Redistribution and use in source and binary forms, with or without
9  * modification, are permitted provided that the following conditions
10  * are met:
11  * 1. Redistributions of source code must retain the above copyright
12  *    notice, this list of conditions and the following disclaimer.
13  * 2. Redistributions in binary form must reproduce the above copyright
14  *    notice, this list of conditions and the following disclaimer in the
15  *    documentation and/or other materials provided with the distribution.
16  * 3. Neither the name of the author nor the names of any co-contributors
17  *    may be used to endorse or promote products derived from this software
18  *    without specific prior written permission.
19  *
20  * THIS SOFTWARE IS PROVIDED BY David Young ``AS IS'' AND ANY
21  * EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO,
22  * THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A
23  * PARTICULAR PURPOSE ARE DISCLAIMED.  IN NO EVENT SHALL David
24  * Young BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL,
25  * EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED
26  * TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE,
27  * DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND
28  * ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY,
29  * OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY
30  * OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY
31  * OF SUCH DAMAGE.
32  */
33 
34 #ifndef _DEV_IC_AL2210REG_H_
35 #define	_DEV_IC_AL2210REG_H_
36 
37 /*
38  * Register definitions for the Airoha AL2210 2.4GHz 802.11b
39  * transceiver.
40  */
41 
42 /* NOTE WELL: These register definitions, in spite of being derived
43  * from an "official" Airoha AL2210 datasheet, contain a lot of
44  * "magic." Comparing with the magic in this header file with a
45  * reference driver that also contains AL2210 magic, the magic does
46  * not match!
47  */
48 
49 /*
50  * Serial bus format for Airoha AL2210 2.4GHz transceiver.
51  */
52 #define	AL2210_TWI_DATA_MASK	__BITS(23, 4)
53 #define	AL2210_TWI_ADDR_MASK	__BITS(3, 0)
54 
55 /*
56  * Registers for Airoha AL2210.
57  */
58 
59 /* The synthesizer magic should be decipherable, but I'm not going
60  * to waste my time right now.
61  */
62 #define AL2210_CHANNEL		0x0
63 #define		AL2210_CHANNEL_B_MASK		__BITS(10, 5)	/* Counter B */
64 #define		AL2210_CHANNEL_B_2412MHZ	0x396
65 #define		AL2210_CHANNEL_B_2417MHZ	0x396
66 #define		AL2210_CHANNEL_B_2422MHZ	0x396
67 #define		AL2210_CHANNEL_B_2427MHZ	0x396
68 #define		AL2210_CHANNEL_B_2432MHZ	0x398
69 #define		AL2210_CHANNEL_B_2437MHZ	0x398
70 #define		AL2210_CHANNEL_B_2442MHZ	0x398
71 #define		AL2210_CHANNEL_B_2447MHZ	0x398
72 #define		AL2210_CHANNEL_B_2452MHZ	0x398
73 #define		AL2210_CHANNEL_B_2457MHZ	0x398
74 #define		AL2210_CHANNEL_B_2462MHZ	0x398
75 #define		AL2210_CHANNEL_B_2467MHZ	0x39a
76 #define		AL2210_CHANNEL_B_2472MHZ	0x39a
77 #define		AL2210_CHANNEL_B_2484MHZ	0x39b
78 #define		AL2210_CHANNEL_A_MASK		__BITS(4, 0)	/* Counter A */
79 #define		AL2210_CHANNEL_A_2412MHZ	0x0c
80 #define		AL2210_CHANNEL_A_2417MHZ	0x11
81 #define		AL2210_CHANNEL_A_2422MHZ	0x16
82 #define		AL2210_CHANNEL_A_2427MHZ	0x1b
83 #define		AL2210_CHANNEL_A_2432MHZ	0x00
84 #define		AL2210_CHANNEL_A_2437MHZ	0x05
85 #define		AL2210_CHANNEL_A_2442MHZ	0x0a
86 #define		AL2210_CHANNEL_A_2447MHZ	0x0f
87 #define		AL2210_CHANNEL_A_2452MHZ	0x14
88 #define		AL2210_CHANNEL_A_2457MHZ	0x10
89 #define		AL2210_CHANNEL_A_2462MHZ	0x1e
90 #define		AL2210_CHANNEL_A_2467MHZ	0x03
91 #define		AL2210_CHANNEL_A_2472MHZ	0x08
92 #define		AL2210_CHANNEL_A_2484MHZ	0x14
93 
94 #define AL2210_SYNTHESIZER	0x1
95 #define		AL2210_SYNTHESIZER_R_MASK	__BITS(4, 0)	/* Reference
96 								 * divider
97 								 */
98 #define AL2210_RECEIVER		0x2
99 /* Rx VAGC Detector Negative Edge Threshold */
100 #define		AL2210_RECEIVER_AGCDET_P_MASK	__BITS(16, 15)
101 #define		AL2210_RECEIVER_AGCDET_P_0_4V	0	/* 0.4V */
102 #define		AL2210_RECEIVER_AGCDET_P_0_3V	1	/* 0.3V */
103 #define		AL2210_RECEIVER_AGCDET_P_0_2V	2	/* 0.2V */
104 #define		AL2210_RECEIVER_AGCDET_P_RSVD	3	/* reserved */
105 /* Rx VAGC Detector Negative Edge Threshold */
106 #define		AL2210_RECEIVER_AGCDET_N_MASK	__BITS(14, 13)
107 #define		AL2210_RECEIVER_AGCDET_N_0_4V	0	/* 0.4V */
108 #define		AL2210_RECEIVER_AGCDET_N_0_3V	1	/* 0.3V */
109 #define		AL2210_RECEIVER_AGCDET_N_0_2V	2	/* 0.2V */
110 #define		AL2210_RECEIVER_AGCDET_N_RSVD	3	/* reserved */
111 /* AGC detector control, 1: enable, 0: disable. */
112 #define		AL2210_RECEIVER_AGCDETENA	__BIT(11)
113 /* Rx filter bandwidth select */
114 #define		AL2210_RECEIVER_BW_SEL_MASK	__BITS(4, 2)
115 #define		AL2210_RECEIVER_BW_SEL_9_5MHZ	0
116 #define		AL2210_RECEIVER_BW_SEL_9MHZ	1
117 #define		AL2210_RECEIVER_BW_SEL_8_5MHZ	2
118 #define		AL2210_RECEIVER_BW_SEL_8MHZ	3
119 #define		AL2210_RECEIVER_BW_SEL_7_5MHZ	4
120 #define		AL2210_RECEIVER_BW_SEL_7MHZ	5
121 #define		AL2210_RECEIVER_BW_SEL_6_5MHZ	6
122 #define		AL2210_RECEIVER_BW_SEL_6MHZ	7
123 
124 #define AL2210_TRANSMITTER	0x3
125 /* 2nd-stage power amplifier current control.  Units of 20uA.
126  * "Full scale" current is 300uA.  (Is full-scale at PABIAS2 = 0 or
127  * at PABIAS2 = 15?)
128  */
129 #define		AL2210_TRANSMITTER_PABIAS2_MASK	__BITS(7, 4)
130 /* 1st-stage power amplifier current control.  Units of 20uA.
131  * "Full scale" current is 300uA.  (Is full-scale at PABIAS2 = 0 or
132  * at PABIAS2 = 15?)
133  */
134 #define		AL2210_TRANSMITTER_PABIAS1_MASK	__BITS(3, 0)
135 
136 #define AL2210_CONFIG1		0x4
137 
138 #define AL2210_CONFIG2		0x5
139 /* Regulator power.  0: on, 1: off. */
140 #define		AL2210_CONFIG2_REGPD_MASK	__BIT(19)
141 /* XO clock setting.   0: 44MHz, 1: 22MHz. */
142 #define		AL2210_CONFIG2_XTAL_SC_MASK	__BIT(10)
143 
144 /* DC Offset Calibration (DCOC) */
145 #define AL2210_CONFIG3		0x6
146 /* Select 1MHz DCOC timing. */
147 #define		AL2210_CONFIG3_AGC_DET_PATT_1MHZ	__BIT(17)
148 /* Select 100kHz DCOC timing. */
149 #define		AL2210_CONFIG3_AGC_DET_PATT_100KHZ	__BIT(16)
150 #define		AL2210_CONFIG3_LNA_GAIN_PATT_1MHZ	__BITS(15)
151 #define		AL2210_CONFIG3_LNA_GAIN_PATT_100KHZ	__BITS(14)
152 #define		AL2210_CONFIG3_RXON_PATT_1MHZ		__BITS(13)
153 #define		AL2210_CONFIG3_RXON_PATT_1OOKHZ		__BITS(12)
154 /* 1MHz DCOC duration?  Microseconds. */
155 #define		AL2210_CONFIG3_CNT_1M_AGC_MASK		__BITS(11, 8)
156 #define		AL2210_CONFIG3_CNT_1M_LNA_MASK		__BITS(7, 4)
157 #define		AL2210_CONFIG3_CNT_1M_RXON_MASK		__BITS(3, 0)
158 
159 #define AL2210_CONFIG4		0x7
160 /* 100kHz DCOC duration?  Microseconds. */
161 #define		AL2210_CONFIG4_CNT_100K_AGC_MASK	__BITS(11, 8)
162 #define		AL2210_CONFIG4_CNT_100K_LNA_MASK	__BITS(7, 4)
163 #define		AL2210_CONFIG4_CNT_100K_RXON_MASK	__BITS(3, 0)
164 
165 #define AL2210_CONFIG5		0x8
166 #define		AL2210_CONFIG5_TXF_BW_MASK		__BITS(9, 8)
167 #define		AL2210_CONFIG5_TXF_BW_12MHZ		3
168 #define		AL2210_CONFIG5_TXF_BW_11MHZ		2
169 #define		AL2210_CONFIG5_TXF_BW_10MHZ		1
170 #define		AL2210_CONFIG5_TXF_BW_9MHZ		0
171 
172 #define AL2210_CONFIG6		0x9
173 #define	AL2210_CONFIG6_DEFAULT	0x2c0009	/* magic */
174 
175 #define AL2210_CONFIG7		0xa
176 #define	AL2210_CONFIG7_DEFAULT	0x001c0a	/* magic */
177 
178 #define AL2210_CONFIG8		0xb
179 #define	AL2210_CONFIG8_DEFAULT	0x01000b	/* magic */
180 
181 #endif /* _DEV_IC_AL2210REG_H_ */
182