Copyright (c) 1980 Regents of the University of California.
All rights reserved. The Berkeley software License Agreement
specifies the terms and conditions for redistribution.

@(#)ht.4 4.1 (Berkeley) 05/15/85

C 4 ht - TM-03/TE-16,TU-45,TU-77 MASSBUS magtape interface formatter ht0 at mba? drive ?

tape tu0 at ht0 slave 0

The tm-03/transport combination provides a standard tape drive interface as described in mt (4). All drives provide both 800 and 1600 bpi; the TE-16 runs at 45 ips, the TU-45 at 75 ips, while the TU-77 runs at 125 ips and autoloads tapes. mt(1), tar(1), tp(1), mtop(4), mt(4), tm(4), ts(4) tu%d: no write ring. An attempt was made to write on the tape drive when no write ring was present; this message is written on the terminal of the user who tried to access the tape.

tu%d: not online. An attempt was made to access the tape while it was offline; this message is written on the terminal of the user who tried to access the tape.

tu%d: can't switch density in mid-tape. An attempt was made to write on a tape at a different density than is already recorded on the tape. This message is written on the terminal of the user who tried to switch the density.

tu%d: hard error bn%d mbsr=%b er=%b ds=%b. A tape error occurred at block bn; the ht error register and drive status register are printed in octal with the bits symbolically decoded. Any error is fatal on non-raw tape; when possible the driver will have retried the operation which failed several times before reporting the error.

If any non-data error is encountered on non-raw tape, it refuses to do anything more until closed.

The system should remember which controlling terminal has the tape drive open and write error messages to that terminal rather than on the console.