| /freebsd-src/sys/contrib/device-tree/src/arm64/broadcom/northstar2/ |
| H A D | ns2-svk.dts | 33 /dts-v1/;
39 compatible = "brcm,ns2-svk", "brcm,ns2";
49 stdout-path = "serial0:115200n8";
113 spi-max-frequency = <5000000>;
114 spi-cpha;
115 spi-cpol;
117 pl022,slave-tx-disabl
[all...] |
| /freebsd-src/sys/contrib/device-tree/Bindings/spi/ |
| H A D | arm,pl022-peripheral-props.yaml | 1 # SPDX-License-Identifier: GPL-2.0
3 ---
4 $id: http://devicetree.org/schemas/spi/arm,pl022-peripheral-props.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: Peripheral-specific properties for Arm PL022 SPI controller
10 - Linus Walleij <linus.walleij@linaro.org>
19 - 0 # SPI
20 - 1 # Texas Instruments Synchronous Serial Frame Format
21 - 2 # Microwire (Half Duplex)
23 pl022,com-mode:
[all …]
|
| H A D | spi-pl022.yaml | 1 # SPDX-License-Identifier: GPL-2.0
3 ---
4 $id: http://devicetree.org/schemas/spi/spi-pl022.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Linus Walleij <linus.walleij@linaro.org>
13 - $ref: spi-controller.yaml#
14 - $ref: /schemas/arm/primecell.yaml#
23 - compatible
28 - const: arm,pl022
29 - const: arm,primecell
[all …]
|
| /freebsd-src/sys/contrib/device-tree/src/arm/st/ |
| H A D | spear1310-evb.dts | 1 // SPDX-License-Identifier: GPL-2.0-or-later
8 /dts-v1/;
13 compatible = "st,spear1310-evb", "st,spear1310";
14 #address-cells = <1>;
15 #size-cells = <1>;
23 pinctrl-names = "default";
24 pinctrl-0 = <&state_default>;
63 smi-pmx {
127 label = "u-boot";
149 compatible = "gpio-keys";
[all …]
|
| H A D | spear1340-evb.dts | 1 // SPDX-License-Identifier: GPL-2.0-or-later
8 /dts-v1/;
13 compatible = "st,spear1340-evb", "st,spear1340";
14 #address-cells = <1>;
15 #size-cells = <1>;
23 pinctrl-names = "default";
24 pinctrl-0 = <&state_default>;
47 spdif-in {
51 spdif-out {
59 smi-pmx {
[all …]
|
| /freebsd-src/sys/contrib/device-tree/src/arm64/amd/ |
| H A D | amd-overdrive.dts | 1 // SPDX-License-Identifier: GPL-2.0
8 /dts-v1/;
10 /include/ "amd-seattle-soc.dtsi"
14 compatible = "amd,seattle-overdrive", "amd,seattle";
17 stdout-path = &serial0;
48 compatible = "mmc-spi-slot";
50 spi-max-frequency = <20000000>;
51 voltage-ranges = <3200 3400>;
53 interrupt-parent = <&gpio0>;
57 pl022,com-mode = <0x0>;
[all …]
|
| H A D | amd-overdrive-rev-b0.dts | 1 // SPDX-License-Identifier: GPL-2.0
9 /dts-v1/;
11 /include/ "amd-seattle-soc.dtsi"
12 /include/ "amd-seattle-cpus.dtsi"
16 compatible = "amd,seattle-overdrive", "amd,seattle";
19 stdout-path = &serial0;
23 compatible = "arm,psci-0.2";
30 amd,zlib-support = <1>;
63 compatible = "mmc-spi-slot";
65 spi-max-frequency = <20000000>;
[all …]
|
| H A D | amd-overdrive-rev-b1.dts | 1 // SPDX-License-Identifier: GPL-2.0
9 /dts-v1/;
11 /include/ "amd-seattle-soc.dtsi"
12 /include/ "amd-seattle-cpus.dtsi"
16 compatible = "amd,seattle-overdrive", "amd,seattle";
19 stdout-path = &serial0;
23 compatible = "arm,psci-0.2";
30 amd,zlib-support = <1>;
75 compatible = "mmc-spi-slot";
77 spi-max-frequency = <20000000>;
[all …]
|
| H A D | husky.dts | 1 // SPDX-License-Identifier: GPL-2.0
4 * Note: Based-on AMD Seattle Rev.B0
9 /dts-v1/;
11 /include/ "amd-seattle-soc.dtsi"
15 compatible = "amd,seattle-overdrive", "amd,seattle";
18 stdout-path = &serial0;
22 compatible = "arm,psci-0.2";
29 amd,zlib-support = <1>;
70 compatible = "mmc-spi-slot";
72 spi-max-frequency = <20000000>;
[all …]
|
| /freebsd-src/sys/contrib/device-tree/src/arm/nxp/lpc/ |
| H A D | lpc3250-phy3250.dts | 1 // SPDX-License-Identifier: GPL-2.0-or-later
3 * PHYTEC phyCORE-LPC3250 board
5 * Copyright (C) 2015-2019 Vladimir Zapolskiy <vz@mleia.com>
9 /dts-v1/;
13 model = "PHYTEC phyCORE-LPC3250 board based on NXP LPC3250";
22 compatible = "gpio-leds";
26 default-state = "off";
31 linux,default-trigger = "heartbeat";
37 power-supply = <®_lcd>;
41 remote-endpoint = <&cldc_output>;
[all …]
|
| /freebsd-src/sys/contrib/dev/iwlwifi/fw/api/ |
| H A D | mac.h | 1 /* SPDX-License-Identifier: GPL-2.0 OR BSD-3-Clause */
3 * Copyright (C) 2012-2014, 2018-2022, 2024 Intel Corporation
11 * AUX indices follows - 1 for non-CDB, 2 for CDB.
31 * enum iwl_mac_protection_flags - MA
[all...] |
| /freebsd-src/sys/dev/acpica/ |
| H A D | acpivar.h | 1 /*-
78 struct apm_clone_data *acpi_clone; /* Pseudo-dev for devd(8). */
106 u_int trig;
153 * Each ACPI device can have its own driver-specific mutex for protecting
160 * ACPI-CA handles its own locking and should not be called with locks held.
163 * GPE -> EC runs _Qxx -> _Qxx reads EC space -> GPE
180 * ACPI CA does not define layers for non-ACPI CA drivers.
205 * See the Intel document titled "Intel Processor Vendor-Specifi
105 u_int trig; global() member
[all...] |
| /freebsd-src/sys/contrib/device-tree/src/arm/qcom/ |
| H A D | qcom-apq8060-dragonboard.dts | 1 // SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
2 #include <dt-bindings/input/input.h>
3 #include <dt-bindings/gpio/gpio.h>
4 #include <dt-bindings/leds/common.h>
5 #include <dt-bindings/pinctrl/qcom,pmic-gpio.h>
6 #include <dt-bindings/pinctrl/qcom,pmic-mpp.h>
7 #include "qcom-msm8660.dtsi"
12 compatible = "qcom,apq8060-dragonboard", "qcom,msm8660";
19 stdout-path = "serial0:115200n8";
23 vph: regulator-fixed {
[all …]
|
| /freebsd-src/sys/dev/qlnx/qlnxe/ |
| H A D | reg_addr.h | 2 * Copyright (c) 2017-2018 Cavium, Inc.
73 … Mask memory read Bit3 : Mask memory write Bit2 : Mask Completion Bit1 : Mask TX Bit0 : Mask RX
76 … 0x003824UL //Access:R DataWidth:0x20 // tx number of tlp sent
78 …- For ending "endless completion". 0 - When receiving a completion timeout while receiving a compl…
79 … DataWidth:0x4 // 0 - TXCPL sync fifo pop underflow 1 - TXR sync fifo pop underflow 2 - TXW hea…
80 …s:R DataWidth:0x6 // 0 - RX target read and config sync fifo push overflow 1 - RX header syn…
81 …ataWidth:0x14 // 4:0 - TXCPL sync fifo pop status 9:5 - TXR sync fifo pop status 14:10 - TXW hea…
88 …ffff<<0) // Vendor ID. PCI-SIG assigned Manufacturer Identifier. Note: The access attributes of …
90 …ce Identifier. Note: The access attributes of this field are as follows: - Dbi: if (DBI_RO_WR_E…
116 … (0x1<<9) // Fast back-to-back transaction ena…
[all …]
|
| /freebsd-src/contrib/wpa/wpa_supplicant/ |
| H A D | p2p_supplicant.c | 2 * wpa_supplicant - P2P
3 * Copyright (c) 2009-2010, Atheros Communications
4 * Copyright (c) 2010-2014, Jouni Malinen <j@w1.fi>
73 * How many seconds to wait for initial 4-way handshake to get completed after
74 * WPS provisioning step or after the re-invocation of a persistent group on a
82 * How many seconds to wait for initial 4-way handshake to get completed after
92 * How many seconds to wait for initial 4-way handshake to get completed after
93 * re-invocation of a persistent group on the GO when the client is expected
99 #define P2P_MGMT_DEVICE_PREFIX "p2p-dev-"
4109 wpas_p2p_debug_print(void * ctx,int level,const char * msg) wpas_p2p_debug_print() argument
8268 wpas_p2p_update_channel_list(struct wpa_supplicant * wpa_s,enum wpas_p2p_channel_update_trig trig) wpas_p2p_update_channel_list() argument
9961 wpas_p2p_consider_moving_gos(struct wpa_supplicant * wpa_s,struct wpa_used_freq_data * freqs,unsigned int num,enum wpas_p2p_channel_update_trig trig) wpas_p2p_consider_moving_gos() argument
[all...] |
| /freebsd-src/share/misc/ |
| H A D | usb_vendors | 6 # http://www.linux-usb.org/usb-ids.html
7 # or send entries as patches (diff -u old new) in the
10 # http://www.linux-usb.org/usb.ids
13 # Date: 2024-12-04 20:34:02
20 # device device_name <-- single tab
21 # interface interface_name <-- tw
[all...] |
| /freebsd-src/contrib/sqlite3/ |
| H A D | sqlite3.c | 17 ** language. The code for the "sqlite3" command-line shell is also in a
20 ** The content in this amalgamation comes from Fossil check-in
51 ** NO_TEST - The branches on this line are not
56 ** OPTIMIZATION-IF-TRUE - This branch is allowed to always be false
60 ** OPTIMIZATION-IF-FALSE - This branch is allowed to always be true
64 ** PREVENTS-HARMLES
25230 DateTime tx; parseModifier() local
35385 volatile double tx, ty, p, q, c, cc; dekkerMul2() local
[all...] |