Home
last modified time | relevance | path

Searched +full:trig +full:- +full:gpios (Results 1 – 6 of 6) sorted by relevance

/freebsd-src/sys/contrib/device-tree/Bindings/iio/proximity/
H A Ddevantech-srf04.yaml1 # SPDX-License-Identifier: GPL-2.0
3 ---
4 $id: http://devicetree.org/schemas/iio/proximity/devantech-srf04.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Andreas Klinger <ak@it-klinger.de>
13 Bit-banging driver using two GPIOs:
14 - trigger-gpio is raised by the driver to start sending out an ultrasonic
16 - echo-gpio is held high by the sensor after sending ultrasonic burst
20 https://www.robot-electronics.co.uk/htm/srf04tech.htm
22 https://www.maxbotix.com/documents/LV-MaxSonar-EZ_Datasheet.pdf
[all …]
/freebsd-src/sys/contrib/device-tree/src/arm/nxp/lpc/
H A Dlpc3250-phy3250.dts1 // SPDX-License-Identifier: GPL-2.0-or-later
3 * PHYTEC phyCORE-LPC3250 board
5 * Copyright (C) 2015-2019 Vladimir Zapolskiy <vz@mleia.com>
9 /dts-v1/;
13 model = "PHYTEC phyCORE-LPC3250 board based on NXP LPC3250";
22 compatible = "gpio-leds";
25 gpios = <&gpio 5 1 0>; /* GPO_P3 1, GPIO 80, active high */
26 default-state = "off";
30 gpios = <&gpio 5 14 0>; /* GPO_P3 14, GPIO 93, active high */
31 linux,default-trigger = "heartbeat";
[all …]
/freebsd-src/sys/contrib/device-tree/src/arm64/amd/
H A Damd-overdrive.dts1 // SPDX-License-Identifier: GPL-2.0
8 /dts-v1/;
10 /include/ "amd-seattle-soc.dtsi"
14 compatible = "amd,seattle-overdrive", "amd,seattle";
17 stdout-path = &serial0;
48 compatible = "mmc-spi-slot";
50 spi-max-frequency = <20000000>;
51 voltage-ranges = <3200 3400>;
52 gpios = <&gpio0 7 0>;
53 interrupt-parent = <&gpio0>;
[all …]
/freebsd-src/sys/contrib/device-tree/src/arm/st/
H A Dspear1310-evb.dts1 // SPDX-License-Identifier: GPL-2.0-or-later
8 /dts-v1/;
13 compatible = "st,spear1310-evb", "st,spear1310";
14 #address-cells = <1>;
15 #size-cells = <1>;
23 pinctrl-names = "default";
24 pinctrl-0 = <&state_default>;
63 smi-pmx {
127 label = "u-boot";
149 compatible = "gpio-keys";
[all …]
H A Dspear1340-evb.dts1 // SPDX-License-Identifier: GPL-2.0-or-later
8 /dts-v1/;
13 compatible = "st,spear1340-evb", "st,spear1340";
14 #address-cells = <1>;
15 #size-cells = <1>;
23 pinctrl-names = "default";
24 pinctrl-0 = <&state_default>;
47 spdif-in {
51 spdif-out {
59 smi-pmx {
[all …]
/freebsd-src/sys/contrib/device-tree/src/arm/qcom/
H A Dqcom-apq8060-dragonboard.dts1 // SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
2 #include <dt-bindings/input/input.h>
3 #include <dt-bindings/gpio/gpio.h>
4 #include <dt-bindings/leds/common.h>
5 #include <dt-bindings/pinctrl/qcom,pmic-gpio.h>
6 #include <dt-bindings/pinctrl/qcom,pmic-mpp.h>
7 #include "qcom-msm8660.dtsi"
12 compatible = "qcom,apq8060-dragonboard", "qcom,msm8660";
19 stdout-path = "serial0:115200n8";
23 vph: regulator-fixed {
[all …]