Home
last modified time | relevance | path

Searched +full:touchscreen +full:- +full:average +full:- +full:samples (Results 1 – 10 of 10) sorted by relevance

/freebsd-src/sys/contrib/device-tree/Bindings/input/touchscreen/
H A Dimx6ul_tsc.txt4 - compatible: must be "fsl,imx6ul-tsc".
5 - reg: this touch controller address and the ADC2 address.
6 - interrupts: the interrupt of this touch controller and ADC2.
7 - clocks: the root clock of touch controller and ADC2.
8 - clock-names; must be "tsc" and "adc".
9 - xnur-gpio: the X- gpio this controller connect to.
10 This xnur-gpio returns to low once the finger leave the touch screen (The
14 - measure-delay-time: the value of measure delay time.
15 Before X-axis or Y-axis measurement, the screen need some time before
18 - pre-charge-time: the touch screen need some time to precharge.
[all …]
H A Dstmpe.txt1 STMPE Touchscreen
2 ----------------
5 - compatible: "st,stmpe-ts"
8 - st,ave-ctrl : Sample average control
9 0 -> 1 sample
10 1 -> 2 samples
11 2 -> 4 samples
12 3 -> 8 samples
13 - st,touch-det-delay : Touch detect interrupt delay (recommended is 3)
14 0 -> 10 us
[all …]
H A Dads7846.txt7 Documentation/devicetree/bindings/spi/spi-bus.txt
23 vcc-supply A regulator node for the supply voltage.
28 ti,vref-delay-usecs vref supply delay in usecs, 0 for
30 ti,vref-mv The VREF voltage, in millivolts (u16).
33 ti,keep-vref-on set to keep vref on for differential
35 ti,settle-delay-usec Settling time of the analog signals;
37 on the X/Y drivers. If set to non-zer
[all...]
H A Dtouchscreen.yaml1 # SPDX-License-Identifier: GPL-2.0
3 ---
4 $id: http://devicetree.org/schemas/input/touchscreen/touchscreen.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: Common touchscreen
10 - Dmitry Torokhov <dmitry.torokhov@gmail.com>
14 description: If this touchscreen is integrally connected to a panel, this
16 that the touchscreen should be power sequenced together with the panel
20 touchscreen-min-x:
25 touchscreen-min-y:
[all …]
/freebsd-src/sys/contrib/device-tree/Bindings/mfd/
H A Dmxs-lradc.txt4 - compatible: Should be "fsl,imx23-lradc" for i.MX23 SoC and "fsl,imx28-lradc"
6 - reg: Address and length of the register set for the device
7 - interrupts: Should contain the LRADC interrupts
10 - fsl,lradc-touchscreen-wires: Number of wires used to connect the touchscreen
12 property is not present, then the touchscreen is
14 - fsl,ave-ctrl: number of samples per direction to calculate an average value.
16 - fsl,ave-delay: delay between consecutive samples. Allowed value is
17 2 ... 2048. It is used if 'fsl,ave-ctrl' > 1, counts at
19 - fsl,settling: delay between plate switch to next sample. Allowed value is
26 compatible = "fsl,imx23-lradc";
[all …]
H A Dst,stmpe.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
11 touchscreen, ADC, PWM or rotator. It can contain one or several different
15 - Linus Walleij <linus.walleij@linaro.org>
18 - $ref: /schemas/spi/spi-peripheral-props.yaml#
23 - st,stmpe601
24 - st,stmpe801
25 - st,stmpe811
26 - st,stmpe1600
[all …]
/freebsd-src/sys/arm/ti/
H A Dti_adc.c1 /*-
94 evdev_push_event(sc->sc_evdev, EV_ABS, ABS_X, sc->sc_x); in ti_adc_ev_report()
95 evdev_push_event(sc->sc_evdev, EV_ABS, ABS_Y, sc->sc_y); in ti_adc_ev_report()
96 evdev_push_event(sc->sc_evdev, EV_KEY, BTN_TOUCH, sc->sc_pen_down); in ti_adc_ev_report()
97 evdev_sync(sc->sc_evdev); in ti_adc_ev_report()
108 if (sc->sc_last_state == 1) in ti_adc_enable()
116 if (sc->sc_tsc_wire in ti_adc_enable()
358 int error, samples, i; ti_adc_samples_avg_proc() local
[all...]
/freebsd-src/sys/contrib/device-tree/src/arm64/freescale/
H A Dimx8mm-var-som.dtsi1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
10 model = "Variscite VAR-SOM-MX8MM module";
13 stdout-path = &uart4;
21 reg_eth_phy: regulator-eth-phy {
22 compatible = "regulator-fixed";
23 pinctrl-name
[all...]
H A Dimx8mn-var-som.dtsi1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
4 * Copyright 2019-2020 Variscite Ltd.
11 model = "Variscite VAR-SOM-MX8MN module";
12 compatible = "variscite,var-som-mx8mn", "fsl,imx8mn";
15 stdout-path = &uart4;
23 reg_eth_phy: regulator-eth-phy {
24 compatible = "regulator-fixed";
25 pinctrl-names = "default";
26 pinctrl-0 = <&pinctrl_reg_eth_phy>;
27 regulator-name = "eth_phy_pwr";
[all …]
/freebsd-src/sys/contrib/device-tree/src/arm/nxp/imx/
H A Dimx6ull-dhcom-som.dtsi1 // SPDX-License-Identifier: GPL-2.0+ OR BSD-3-Clause
6 #include "imx6ull-dhcor-som.dtsi"
10 /delete-property/ spi2;
11 /delete-property/ spi3;
28 stdout-pat
[all...]