/freebsd-src/sys/contrib/device-tree/Bindings/soc/fsl/cpm_qe/ |
H A D | fsl,cpm1-tsa.yaml | 1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) 3 --- 4 $id: http://devicetree.org/schemas/soc/fsl/cpm_qe/fsl,cpm1-tsa.yaml# 5 $schema: http://devicetree.org/meta-schemas/core.yaml# 7 title: PowerQUICC CPM Time-slot assigner (TSA) controller 10 - Herve Codina <herve.codina@bootlin.com> 13 The TSA is the time-slot assigner that can be found on some PowerQUICC SoC. 14 Its purpose is to route some TDM time-slots to other internal serial 20 - enum: 21 - fsl,mpc885-tsa [all …]
|
/freebsd-src/sys/contrib/device-tree/src/arm/nxp/imx/ |
H A D | imx6qdl-dhcom-drc02.dtsi | 1 // SPDX-License-Identifier: GPL-2.0+ 8 stdout-path = "serial0:115200n8"; 13 * Special SoM hardware required which uses the pins from micro SD card. The 14 * pins SD3_DAT0 and SD3_DAT1 are muxed as can2 Tx and Rx. The signals for can2 15 * Tx and Rx are routed to the DHCOM UART1 rts/cts pins. Therefore the micro SD 17 * pins, see uart1 and usdhc3 node below. 26 * GPIO line, however the i.MX6 UART driver assumes RX happens 28 * line. Hence, the RX is always enabled here. 30 rs485-rx-en-hog { 31 gpio-hog; [all …]
|
/freebsd-src/sys/contrib/device-tree/src/arm64/qcom/ |
H A D | sa8540p-ride.dts | 1 // SPDX-License-Identifier: BSD-3-Clause 7 /dts-v1/; 9 #include <dt-bindings/gpio/gpio.h> 10 #include <dt-bindings/regulator/qcom,rpmh-regulator.h> 13 #include "sa8540p-pmics.dtsi" 17 compatible = "qcom,sa8540p-rid [all...] |
H A D | qcs404-evb-4000.dts | 1 // SPDX-License-Identifier: GPL-2.0 6 /dts-v1/; 8 #include <dt-bindings/gpio/gpio.h> 9 #include "qcs404-evb.dtsi" 13 compatible = "qcom,qcs404-evb-4000", "qcom,qcs404-evb", 20 snps,reset-gpio = <&tlmm 60 GPIO_ACTIVE_LOW>; 21 snps,reset-active-low; 22 snps,reset-delays-us = <0 10000 10000>; 24 pinctrl-names = "default"; 25 pinctrl-0 = <ðernet_defaults>; [all …]
|
H A D | sa8775p-ride.dts | 1 // SPDX-License-Identifier: BSD-3-Clause 6 /dts-v1/; 8 #include "sa8775p-ride.dtsi" 12 compatible = "qcom,sa8775p-ride", "qcom,sa8775p"; 16 phy-mode = "sgmii"; 20 phy-mode = "sgmii"; 24 compatible = "snps,dwmac-mdi [all...] |
H A D | x1e80100.dtsi | 1 // SPDX-License-Identifier: BSD-3-Clause 6 #include <dt-bindings/clock/qcom,rpmh.h> 7 #include <dt-bindings/clock/qcom,sc8280xp-lpasscc.h> 8 #include <dt-bindings/clock/qcom,x1e80100-dispcc.h> 9 #include <dt-binding [all...] |
H A D | sm6125.dtsi | 1 // SPDX-License-Identifier: BSD-3-Clause 6 #include <dt-bindings/clock/qcom,dispcc-sm6125.h> 7 #include <dt-bindings/clock/qcom,gcc-sm6125.h> 8 #include <dt-bindings/clock/qcom,rpmcc.h> 9 #include <dt-binding [all...] |
H A D | msm8994.dtsi | 1 // SPDX-License-Identifier: GPL-2.0-only 3 * Copyright (c) 2013-2016, The Linux Foundation. All rights reserved. 6 #include <dt-bindings/interrupt-controller/arm-gic.h> 7 #include <dt-bindings/clock/qcom,gcc-msm899 [all...] |
/freebsd-src/sys/contrib/device-tree/src/arm/rockchip/ |
H A D | rk3066a.dtsi | 1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT) 7 #include <dt-bindings/gpio/gpio.h> 8 #include <dt-bindings/pinctrl/rockchip.h> 9 #include <dt-bindings/clock/rk3066a-cru.h> 10 #include <dt-bindings/power/rk3066-power.h> 22 #address-cell [all...] |
H A D | rk3128.dtsi | 1 // SPDX-License-Identifier: GPL-2.0+ 6 #include <dt-bindings/clock/rk3128-cru.h> 7 #include <dt-bindings/gpio/gpio.h> 8 #include <dt-bindings/interrupt-controller/arm-gic.h> 9 #include <dt-binding [all...] |
/freebsd-src/sys/contrib/device-tree/src/arm64/xilinx/ |
H A D | zynqmp-zc1751-xm016-dc2.dts | 1 // SPDX-License-Identifier: GPL-2.0+ 3 * dts file for Xilinx ZynqMP zc1751-xm016-dc2 5 * (C) Copyright 2015 - 2022, Xilinx, Inc. 6 * (C) Copyright 2022 - 2023, Advanced Micro Devices, Inc. 11 /dts-v1/; 14 #include "zynqmp-clk-cc [all...] |
/freebsd-src/sys/contrib/device-tree/src/arm/microchip/ |
H A D | sama5d3.dtsi | 1 // SPDX-License-Identifier: GPL-2.0-or-later 3 * sama5d3.dtsi - Device Tree Include file for SAMA5D3 family SoC 10 #include <dt-bindings/dma/at91.h> 11 #include <dt-bindings/pinctrl/at91.h> 12 #include <dt-bindings/interrupt-controlle [all...] |
H A D | sama5d4.dtsi | 1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT) 3 * sama5d4.dtsi - Device Tree Include file for SAMA5D4 family SoC 9 #include <dt-bindings/clock/at91.h> 10 #include <dt-bindings/dma/at91.h> 11 #include <dt-bindings/mfd/at91-usart.h> 12 #include <dt-bindings/pinctrl/at91.h> 13 #include <dt-binding [all...] |
H A D | at91sam9x5.dtsi | 1 // SPDX-License-Identifier: GPL-2.0-or-later 3 * at91sam9x5.dtsi - Device Tree Include file for AT91SAM9x5 family SoC 11 #include <dt-bindings/dma/at91.h> 12 #include <dt-bindings/pinctrl/at91.h> 13 #include <dt-bindings/interrupt-controlle [all...] |
/freebsd-src/sys/contrib/device-tree/src/arm64/ti/ |
H A D | k3-j784s4-evm.dts | 1 // SPDX-License-Identifier: GPL-2.0-only OR MIT 3 * Copyright (C) 2022-2024 Texas Instruments Incorporated - https://www.ti.com/ 8 /dts-v1/; 10 #include <dt-bindings/net/ti-dp83867.h> 11 #include <dt-binding [all...] |
H A D | k3-am69-sk.dts | 1 // SPDX-License-Identifier: GPL-2.0-only OR MIT 3 * Copyright (C) 2022-2024 Texas Instruments Incorporated - https://www.ti.com/ 9 /dts-v1/; 11 #include <dt-bindings/net/ti-dp83867.h> 12 #include <dt-binding [all...] |
H A D | k3-am64-phycore-som.dtsi | 1 // SPDX-License-Identifier: GPL-2.0-only OR MIT 3 * Copyright (C) 2021-2024 PHYTEC America, LLC - https://www.phytec.com 6 * Copyright (C) 2022-2024 PHYTEC Messtechnik GmbH 10 * https://www.phytec.com/product/phycore-am64x 13 #include <dt-bindings/gpio/gpio.h> 14 #include <dt-binding [all...] |
H A D | k3-j721e-beagleboneai64.dts | 1 // SPDX-License-Identifier: GPL-2.0-only OR MIT 3 * https://beagleboard.org/ai-64 4 * Copyright (C) 2022-2024 Texas Instruments Incorporated - https://www.ti.com/ 5 * Copyright (C) 2022-2024 Jason Kridner, BeagleBoard.org Foundation 6 * Copyright (C) 2022-2024 Robert Nelson, BeagleBoard.org Foundation 9 /dts-v [all...] |
H A D | k3-am62p5-sk.dts | 1 // SPDX-License-Identifier: GPL-2.0-only OR MIT 3 * Device Tree file for the AM62P5-SK 4 * Copyright (C) 2023-2024 Texas Instruments Incorporated - https://www.ti.com/ 9 /dts-v1/; 11 #include <dt-bindings/leds/common.h> 12 #include <dt-binding [all...] |
H A D | k3-am642-sk.dts | 1 // SPDX-License-Identifier: GPL-2.0-only OR MIT 3 * Copyright (C) 2024 Texas Instruments Incorporated - https://www.ti.com/ 6 /dts-v1/; 8 #include <dt-bindings/phy/phy.h> 9 #include <dt-bindings/gpio/gpio.h> 10 #include <dt-bindings/net/ti-dp8386 [all...] |
/freebsd-src/sys/contrib/device-tree/src/riscv/allwinner/ |
H A D | sunxi-d1s-t113.dtsi | 1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT) 2 // Copyright (C) 2021-2022 Samuel Holland <samuel@sholland.org> 4 #include <dt-bindings/clock/sun6i-rtc.h> 5 #include <dt-bindings/clock/sun8i-de2.h> 6 #include <dt-bindings/clock/sun8i-tco [all...] |
/freebsd-src/sys/contrib/device-tree/Bindings/media/ |
H A D | st-rc.txt | 1 Device-Tree bindings for ST IRB IP 4 - compatible: Should contain "st,comms-irb". 5 - reg: Base physical address of the controller and length of memory 7 - interrupts: interrupt-specifier for the sole interrupt generated by 10 - rx-mode: can be "infrared" or "uhf". This property specifies the L1 11 protocol used for receiving remote control signals. rx-mode should 12 be present iff the rx pins are wired up. 13 - tx-mode: should be "infrared". This property specifies the L1 14 protocol used for transmitting remote control signals. tx-mode should 15 be present iff the tx pins are wired up. [all …]
|
/freebsd-src/sys/contrib/device-tree/src/arm/broadcom/ |
H A D | bcm2835-common.dtsi | 1 // SPDX-License-Identifier: GPL-2.0 8 interrupt-parent = <&intc>; 11 dma: dma-controller@7e007000 { 12 compatible = "brcm,bcm2835-dma"; 25 /* dma channel 11-14 share one irq */ 32 interrupt-names = "dma0", 47 "dma-shared-all"; 48 #dma-cells = <1>; 49 brcm,dma-channel-mask = <0x7f35>; 52 intc: interrupt-controller@7e00b200 { [all …]
|
H A D | bcm2711.dtsi | 1 // SPDX-License-Identifier: GPL-2.0 4 #include <dt-bindings/interrupt-controller/arm-gic.h> 5 #include <dt-bindings/soc/bcm2835-pm.h> 10 #address-cells = <2>; 11 #size-cell [all...] |
/freebsd-src/sys/contrib/device-tree/src/arm/allwinner/ |
H A D | sunxi-h3-h5.dtsi | 4 * This file is dual-licensed: you can use it either under the terms 43 #include <dt-bindings/clock/sun6i-rtc.h> 44 #include <dt-bindings/clock/sun8i-de2.h> 45 #include <dt-bindings/clock/sun8i-h3-ccu.h> 46 #include <dt-bindings/clock/sun8i- [all...] |