Home
last modified time | relevance | path

Searched +full:peak +full:- +full:to +full:- +full:peak (Results 1 – 25 of 166) sorted by relevance

1234567

/freebsd-src/sys/contrib/device-tree/Bindings/sound/
H A Dcirrus,cs35l41.yaml1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - david.rhodes@cirrus.com
19 - cirrus,cs35l40
20 - cirrus,cs35l41
28 '#sound-dai-cells':
33 reset-gpios:
36 VA-supply:
39 VP-supply:
[all …]
H A Dcs35l34.txt5 - compatible : "cirrus,cs35l34"
7 - reg : the I2C address of the device for I2C.
9 - VA-supply, VP-supply : power supplies for the device,
13 - cirrus,boost-vtge-millivolt : Boost Voltage Value. Configures the boost
14 converter's output voltage in mV. The range is from VP to 8V with
17 - cirrus,boost-nanohenry: Inductor value for boost converter. The value is
22 - reset-gpios: GPIO used to reset the amplifier.
24 - interrupts : IRQ line info CS35L34.
25 (See Documentation/devicetree/bindings/interrupt-controller/interrupts.txt
26 for further information relating to interrupt properties)
[all …]
H A Dcs35l36.txt5 - compatible : "cirrus,cs35l36"
7 - reg : the I2C address of the device for I2C
9 - VA-supply, VP-supply : power supplies for the device,
13 - cirrus,boost-ctl-millivolt : Boost Voltage Value. Configures the boost
14 converter's output voltage in mV. The range is from 2550mV to 12000mV with
18 - cirrus,boost-peak-milliamp : Boost-converter peak current limit in mA.
19 Configures the peak current by monitoring the current through the boost FET.
20 Range starts at 1600mA and goes to a maximum of 4500mA with increments of
24 - cirrus,boost-ind-nanohenry : Inductor estimation LBST reference value.
26 inductance value to reference.
[all …]
H A Dcs35l35.txt5 - compatible : "cirrus,cs35l35"
7 - reg : the I2C address of the device for I2C
9 - VA-supply, VP-supply : power supplies for the device,
13 - interrupts : IRQ line info CS35L35.
14 (See Documentation/devicetree/bindings/interrupt-controller/interrupts.txt
15 for further information relating to interrupt properties)
17 - cirrus,boost-ind-nanohenry: Inductor value for boost converter. The value is
21 - reset-gpios : gpio used to reset the amplifier
23 - cirrus,stereo-config : Boolean to determine if there are 2 AMPs for a
26 - cirrus,audio-channel : Set Location of Audio Signal on Serial Port
[all …]
/freebsd-src/sys/contrib/device-tree/src/arm64/qcom/
H A Dsdm660.dtsi1 // SPDX-License-Identifier: GPL-2.0-only
13 compatible = "qcom,adreno-512.0", "qcom,adreno";
14 operating-points-v2 = <&gpu_sdm660_opp_table>;
16 gpu_sdm660_opp_table: opp-table {
17 compatible = "operating-points-v2";
21 * Though it cannot be used for now due to interconnect
23 * at the same opp-level
25 opp-750000000 {
26 opp-hz = /bits/ 64 <750000000>;
27 opp-level = <RPM_SMD_LEVEL_TURBO>;
[all …]
H A Dsm6350.dtsi1 // SPDX-License-Identifier: BSD-3-Clause
7 #include <dt-bindings/clock/qcom,dispcc-sm6350.h>
8 #include <dt-bindings/clock/qcom,gcc-sm6350.h>
9 #include <dt-bindings/clock/qcom,gpucc-sm635
[all...]
H A Dsc8280xp.dtsi1 // SPDX-License-Identifier: BSD-3-Clause
7 #include <dt-bindings/clock/qcom,dispcc-sc8280xp.h>
8 #include <dt-bindings/clock/qcom,gcc-sc8280xp.h>
9 #include <dt-bindings/clock/qcom,gpucc-sc8280x
[all...]
H A Dmsm8996.dtsi1 // SPDX-License-Identifier: GPL-2.0-only
3 * Copyright (c) 2014-2015, The Linux Foundation. All rights reserved.
6 #include <dt-bindings/interrupt-controller/arm-gic.h>
7 #include <dt-bindings/clock/qcom,gcc-msm899
[all...]
H A Dsdm845.dtsi1 // SPDX-License-Identifier: GPL-2.0
8 #include <dt-bindings/clock/qcom,camcc-sdm845.h>
9 #include <dt-bindings/clock/qcom,dispcc-sdm845.h>
10 #include <dt-bindings/clock/qcom,gcc-sdm845.h>
11 #include <dt-binding
[all...]
H A Dsm8250.dtsi1 // SPDX-License-Identifier: BSD-3-Clause
6 #include <dt-bindings/interrupt-controller/arm-gic.h>
7 #include <dt-bindings/clock/qcom,dispcc-sm8250.h>
8 #include <dt-binding
[all...]
H A Dsc7180.dtsi1 // SPDX-License-Identifier: BSD-3-Clause
5 * Copyright (c) 2019-2020, The Linux Foundation. All rights reserved.
8 #include <dt-bindings/clock/qcom,dispcc-sc7180.h>
9 #include <dt-bindings/clock/qcom,gcc-sc7180.h>
10 #include <dt-binding
[all...]
H A Dsdm670.dtsi1 // SPDX-License-Identifier: GPL-2.0
9 #include <dt-bindings/clock/qcom,dispcc-sdm845.h>
10 #include <dt-bindings/clock/qcom,gcc-sdm845.h>
11 #include <dt-bindings/clock/qcom,rpmh.h>
12 #include <dt-bindings/dma/qcom-gp
[all...]
H A Dsm8150.dtsi1 // SPDX-License-Identifier: BSD-3-Clause
3 * Copyright (c) 2017-2019, The Linux Foundation. All rights reserved.
7 #include <dt-bindings/dma/qcom-gpi.h>
8 #include <dt-bindings/firmware/qcom,scm.h>
9 #include <dt-bindings/interrupt-controlle
[all...]
H A Dsc7280.dtsi1 // SPDX-License-Identifier: BSD-3-Clause
5 * Copyright (c) 2020-2021, The Linux Foundation. All rights reserved.
7 #include <dt-bindings/clock/qcom,camcc-sc7280.h>
8 #include <dt-bindings/clock/qcom,dispcc-sc7280.h>
9 #include <dt-binding
[all...]
H A Dsm6375.dtsi1 // SPDX-License-Identifier: BSD-3-Clause
6 #include <dt-bindings/clock/qcom,rpmcc.h>
7 #include <dt-bindings/clock/qcom,sm6375-gcc.h>
8 #include <dt-bindings/clock/qcom,sm6375-gpucc.h>
9 #include <dt-binding
[all...]
H A Dsc8180x.dtsi1 // SPDX-License-Identifier: BSD-3-Clause
3 * Copyright (c) 2017-2019, The Linux Foundation. All rights reserved.
4 * Copyright (c) 2020-2023, Linaro Limited
7 #include <dt-bindings/clock/qcom,dispcc-sm8250.h>
8 #include <dt-bindings/clock/qcom,gcc-sc8180
[all...]
/freebsd-src/sys/contrib/device-tree/Bindings/phy/
H A Dtransmit-amplitude.yaml1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/phy/transmit-amplitude.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 Binding describing the peak-to-peak transmit amplitude for common PHYs
14 - Marek Behún <kabel@kernel.org>
17 tx-p2p-microvolt:
19 Transmit amplitude voltages in microvolts, peak-to-peak. If this property
21 'tx-p2p-microvolt-names' property must be provided and contain
24 tx-p2p-microvolt-names:
[all …]
/freebsd-src/share/man/man4/
H A Dng_car.415 .\" ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE
19 .\" DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS
39 .Bl -bullet -compact
45 RED-like rate limit algorithm used by Cisco,
51 .Bl -tag -width ".Va upper"
53 Hook leading to upper layer protocols.
55 Hook leading to lower layer protocols.
74 .Bl -tag -width foo
83 Committed burst packets are counted as green, peak burst packets are counted
86 Peak burst getting refilled with PIR (Peak Information Rate) speed at the
[all …]
/freebsd-src/sys/contrib/device-tree/src/arm64/nvidia/
H A Dtegra234.dtsi1 // SPDX-License-Identifier: GPL-2.0
3 #include <dt-bindings/clock/tegra234-clock.h>
4 #include <dt-bindings/gpio/tegra234-gpio.h>
5 #include <dt-bindings/interrupt-controller/arm-gi
[all...]
/freebsd-src/sys/contrib/device-tree/Bindings/arm/tegra/
H A Dnvidia,tegra30-actmon.txt4 components in the system. This information can be used to derive the rate at
5 which the external memory needs to be clocked in order to serve all requests
9 - compatible: should be "nvidia,tegra<chip>-actmon"
10 - reg: offset and length of the register set for the device
11 - interrupts: standard interrupt property
12 - clocks: Must contain a phandle and clock specifier pair for each entry in
13 clock-names. See ../../clock/clock-bindings.txt for details.
14 - clock-names: Must include the following entries:
15 - actmon
16 - emc
[all …]
/freebsd-src/sys/net/altq/
H A Daltq_cdnr.h1 /*-
2 * Copyright (C) 1999-2002
15 * ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE
19 * DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS
41 #define TCETYPE_TRTCM 4 /* (two-rate) three color marker */
42 #define TCETYPE_TSWTCM 5 /* time sliding window 3-color maker */
92 /* token-bucket meter operations */
115 /* two-rate three-color marker operations */
119 struct tb_profile peak_profile; /* profile for peak tb */
123 int coloraware; /* color-aware/color-blind */
[all …]
/freebsd-src/sys/contrib/device-tree/Bindings/display/msm/
H A Dgpu.txt4 - compatible: "qcom,adreno-XYZ.W", "qcom,adreno" or
5 "amd,imageon-XYZ.W", "amd,imageon"
6 for example: "qcom,adreno-306.0", "qcom,adreno"
7 Note that you need to list the less specific "qcom,adreno" (since this
8 is what the device is matched on), in addition to the more specific
9 with the chip-id.
11 - reg: Physical base address and length of the controller's registers.
12 - interrupts: The interrupt signal from the gpu.
13 - clocks: device clocks (if applicable)
14 See ../clocks/clock-bindings.txt for details.
[all …]
H A Dgpu.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
6 $schema: http://devicetree.org/meta-schema
[all...]
/freebsd-src/sys/dev/sound/pcm/
H A Dchannel_if.m1 #-
4 # Copyright (c) 2005-2009 Ariff Abdullah <ariff@FreeBSD.org>
5 # Portions Copyright (c) Ryan Beasley <ryan.beasley@gmail.com> - GSoC 2006
19 # ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE
23 # DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS
71 return -1;
172 * @brief Retrieve channel peak values
174 * This function is intended to obtain peak volume values for samples
175 * played/recorded on a channel. Values are on a linear scale from 0 to
180 * operation should return EINVAL. However, we may opt to provide
[all …]
/freebsd-src/sys/contrib/device-tree/Bindings/opp/
H A Dopp-v2-base.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/opp/opp-v
[all...]

1234567