Home
last modified time | relevance | path

Searched +full:ovp +full:- +full:voltage (Results 1 – 20 of 20) sorted by relevance

/freebsd-src/sys/contrib/device-tree/Bindings/regulator/
H A Dvctrl.txt1 Bindings for Voltage controlled regulators
5 --------------------
6 - compatible : must be "vctrl-regulator".
7 - regulator-min-microvolt : smallest voltage consumers may set
8 - regulator-max-microvolt : largest voltage consumers may set
9 - ctrl-supply : The regulator supplying the control voltage.
10 - ctrl-voltage-range : an array of two integer values describing the range
11 (min/max) of the control voltage. The values specify
12 the control voltage needed to generate the corresponding
13 regulator-min/max-microvolt output voltage.
[all …]
H A Dmps,mpq7920.yaml1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Saravanan Sekar <sravanhome@gmail.com>
14 pattern: "pmic@[0-9a-f]{1,2}"
17 - mps,mpq7920
27 after their hardware counterparts BUCK[1-4], one LDORTC, and LDO[2-5]
30 mps,switch-freq:
44 "^ldo[1-4]$":
49 "^buck[1-4]$":
[all …]
/freebsd-src/sys/contrib/device-tree/Bindings/power/supply/
H A Dbq24257.txt1 Binding for TI bq24250/bq24251/bq24257 Li-Ion Charger
4 - compatible: Should contain one of the following:
8 - reg: integer, i2c address of the device.
9 - interrupts: Interrupt mapping for GPIO IRQ (configure for both edges). Use in
10 conjunction with "interrupt-parent".
11 - ti,battery-regulation-voltage: integer, maximum charging voltage in uV.
12 - ti,charge-current: integer, maximum charging current in uA.
13 - ti,termination-current: integer, charge will be terminated when current in
14 constant-voltage phase drops below this value (in uA).
17 - pg-gpios: GPIO used for connecting the bq2425x device PG (Power Good) pin.
[all …]
H A Dbq25980.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
4 ---
6 $schema: http://devicetree.org/meta-schemas/core.yaml#
11 - Andrew Davis <afd@ti.com>
15 for use in high-power density portable electronics. These inductorless
20 - $ref: power-supply.yaml#
25 - ti,bq25980
26 - ti,bq25975
27 - ti,bq25960
32 ti,watchdog-timeout-ms:
[all …]
H A Dbq24257.yaml1 # SPDX-License-Identifier: GPL-2.0
4 ---
6 $schema: http://devicetree.org/meta-schemas/core.yaml#
8 title: Bq24250, bq24251 and bq24257 Li-Ion Charger
11 - Sebastian Reichel <sre@kernel.org>
14 - $ref: power-supply.yaml#
19 - ti,bq24250
20 - ti,bq24251
21 - ti,bq24257
29 ti,battery-regulation-voltage:
[all …]
H A Dmaxim,max14577.yaml1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Krzysztof Kozlowski <krzk@kernel.org>
22 - maxim,max14577-charger
23 - maxim,max77836-charger
25 maxim,constant-uvolt:
27 Battery Constant Voltage in uV
32 maxim,eoc-uamp:
34 Current in uA for End-Of-Charge mode.
[all …]
/freebsd-src/sys/contrib/device-tree/Bindings/leds/backlight/
H A Dqcom-wled.yaml1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/leds/backlight/qcom-wled.yaml#
5 $schema: http://devicetree.org/meta-schema
[all...]
H A Dmediatek,mt6370-backlight.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/leds/backlight/mediatek,mt6370-backlight.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - ChiaEn Wu <chiaen_wu@richtek.com>
14 The MT6370 Backlight WLED driver supports up to a 29V output voltage for
21 - $ref: common.yaml#
26 - mediatek,mt6370-backlight
27 - mediatek,mt6372-backlight
29 default-brightness:
[all …]
/freebsd-src/sys/contrib/device-tree/Bindings/mfd/
H A Dmax14577.txt1 Maxim MAX14577/77836 Multi-Function Device
3 MAX14577 is a Multi-Function Device with Micro-USB Interface Circuit, Li+
13 - compatible : Must be "maxim,max14577" or "maxim,max77836".
14 - reg : I2C slave address for the max14577 chip (0x25 for max14577/max77836)
15 - interrupts : IRQ line for the chip.
19 - charger :
22 - compatible : "maxim,max14577-charger"
23 or "maxim,max77836-charger"
24 - maxim,fast-charge-uamp : Current in uA for Fast Charge;
26 - for max14577: 90000 - 950000;
[all …]
H A Dmaxim,max14577.yaml1 # SPDX-License-Identifier: GPL-2.0-only
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Krzysztof Kozlowski <krzk@kernel.org>
17 includes voltage safeout regulators, charger and MicroUSB management IC.
20 includes voltage safeout and LDO regulators, charger, fuel-gauge and MicroUSB
26 - maxim,max14577
27 - maxim,max77836
35 wakeup-source: true
46 - maxim,max14577-muic
[all …]
H A Drichtek,rt4831.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
5 $schema: http://devicetree.org/meta-schema
[all...]
/freebsd-src/sys/contrib/device-tree/Bindings/extcon/
H A Dextcon-rt8973a.txt2 * Richtek RT8973A - Micro USB Switch device
4 The Richtek RT8973A is Micro USB Switch with OVP and I2C interface. The RT8973A
6 voltage system from abnormal high input voltage (up to 28V) and supports high
7 speed USB operation. Also, RT8973A support 'auto-configuration' mode.
8 If auto-configuration mode is enabled, RT8973A would control internal h/w patch
9 for USB D-/D+ switching.
12 - compatible: Should be "richtek,rt8973a-muic"
13 - reg: Specifies the I2C slave address of the MUIC block. It should be 0x14
14 - interrupts: Interrupt specifiers for detection interrupt sources.
19 compatible = "richtek,rt8973a-muic";
[all …]
/freebsd-src/sys/contrib/device-tree/src/arm64/rockchip/
H A Drk3399-gru.dtsi1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
5 * Copyright 2016-2017 Google, Inc
8 #include <dt-bindings/input/input.h>
9 #include "rk3399-op1.dtsi"
18 stdout-path = "serial2:115200n8";
27 * - Rails that only connect to the EC (or devices that the EC talks to)
29 * - Rails _are_ included if the rails go to the AP even if the AP
38 * - Th
[all...]
H A Drk3399-gru-chromebook.dtsi1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
3 * Google Gru-Chromebook shared properties
8 #include "rk3399-gru.dtsi"
11 pp900_ap: pp900-ap {
12 compatible = "regulator-fixed";
13 regulator-name = "pp900_ap";
16 regulator-always-on;
17 regulator-boot-on;
18 regulator-min-microvolt = <900000>;
19 regulator-max-microvolt = <900000>;
[all …]
/freebsd-src/sys/contrib/device-tree/src/arm/qcom/
H A Dqcom-msm8974-sony-xperia-rhine.dtsi1 // SPDX-License-Identifier: GPL-2.0
2 #include "qcom-msm8974.dtsi"
5 #include <dt-bindings/input/input.h>
6 #include <dt-bindings/leds/common.h>
7 #include <dt-bindings/pinctrl/qcom,pmic-gpio.h>
15 stdout-path = "serial0:115200n8";
18 gpio-keys {
19 compatible = "gpio-keys";
21 pinctrl-names = "default";
22 pinctrl-0 = <&gpio_keys_pin_a>;
[all …]
/freebsd-src/sys/contrib/device-tree/src/arm64/qcom/
H A Dsdm845-xiaomi-beryllium-common.dtsi1 // SPDX-License-Identifier: GPL-2.0
3 /dts-v1/;
5 #include <dt-bindings/leds/common.h>
6 #include <dt-bindings/pinctrl/qcom,pmic-gpio.h>
7 #include <dt-bindings/regulator/qcom,rpmh-regulator.h>
8 #include <dt-bindings/sound/qcom,q6afe.h>
9 #include <dt-bindings/sound/qcom,q6asm.h>
11 #include "sdm845-wcd9340.dtsi"
19 /delete-node/ &tz_mem;
20 /delete-node/ &adsp_mem;
[all …]
H A Dsdm845-xiaomi-polaris.dts1 // SPDX-License-Identifier: BSD-3-Clause
7 /dts-v1/;
9 #include <dt-bindings/gpio/gpio.h>
10 #include <dt-bindings/pinctrl/qcom,pmic-gpio.h>
11 #include <dt-bindings/regulator/qcom,rpmh-regulator.h>
12 #include <dt-bindings/input/linux-event-codes.h>
13 #include <dt-bindings/sound/qcom,q6afe.h>
14 #include <dt-bindings/sound/qcom,q6asm.h>
16 #include "sdm845-wcd9340.dtsi"
25 /delete-node/ &rmtfs_mem;
[all …]
H A Dsdm845-sony-xperia-tama.dtsi1 // SPDX-License-Identifier: BSD-3-Clause
6 #include <dt-bindings/input/input.h>
7 #include <dt-bindings/pinctrl/qcom,pmic-gpio.h>
8 #include <dt-bindings/regulator/qcom,rpmh-regulator.h>
15 qcom,msm-id = <321 0x20001>; /* SDM845 v2.1 */
16 qcom,board-id = <8 0>;
24 stdout-path = "serial0:115200n8";
27 gpio-keys {
28 compatible = "gpio-keys";
30 pinctrl-0 = <&focus_n &snapshot_n &vol_down_n &vol_up_n>;
[all …]
/freebsd-src/sys/contrib/device-tree/src/arm64/freescale/
H A Dimx8mq-librem5.dtsi1 // SPDX-License-Identifier: GPL-2.0+
3 * Copyright 2018-2020 Purism SPC
6 /dts-v1/;
8 #include "dt-bindings/input/input.h"
9 #include <dt-bindings/interrupt-controller/irq.h>
10 #include <dt-bindings/leds/common.h>
11 #include "dt-binding
[all...]
/freebsd-src/sys/contrib/device-tree/src/arm/samsung/
H A Dexynos3250-monk.dts1 // SPDX-License-Identifier: GPL-2.0
12 /dts-v1/;
14 #include "exynos4412-ppmu-common.dtsi"
15 #include <dt-bindings/input/input.h>
16 #include <dt-bindings/gpio/gpio.h>
17 #include <dt-bindings/clock/samsung,s2mps11.h>
34 compatible = "samsung,secure-firmware";
38 gpio-keys {
39 compatible = "gpio-keys";
41 power-key {
[all …]