Searched +full:mpc8544 +full:- +full:i2c (Results 1 – 6 of 6) sorted by relevance
/freebsd-src/sys/contrib/device-tree/Bindings/i2c/ |
H A D | i2c-mpc.txt | 1 * I2C 5 - reg : Offset and length of the register set for the device 6 - compatible : should be "fsl,CHIP-i2c" where CHIP is the name of a 7 compatible processor, e.g. mpc8313, mpc8543, mpc8544, mpc5121, 9 "fsl,mpc5121-i2c-ctrl" is required as shown in the example below. 13 - interrupts : <a b> where a is the interrupt number and b is a 18 - fsl,preserve-clocking : boolean; if defined, the clock settings 20 - clock-frequency : desired I2C bus clock frequency in Hz. 21 - fsl,timeout : I2C bus timeout in microseconds. 26 i2c@1740 { [all …]
|
H A D | i2c-mpc.yaml | 1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) 3 --- 4 $id: http://devicetree.org/schemas/i2c/i2 [all...] |
/freebsd-src/sys/contrib/device-tree/src/powerpc/ |
H A D | socrates.dts | 1 // SPDX-License-Identifier: GPL-2.0-or-later 3 * Device Tree Source for the Socrates board (MPC8544). 9 /dts-v1/; 14 #address-cells = <1>; 15 #size-cells = <1>; 26 #address-cells = <1>; 27 #size-cells = <0>; 32 d-cache-line-size = <32>; 33 i-cache-line-size = <32>; 34 d-cache-size = <0x8000>; // L1, 32K [all …]
|
/freebsd-src/sys/contrib/device-tree/src/powerpc/fsl/ |
H A D | mpc8544si-post.dtsi | 2 * MPC8544 Silicon/SoC Device Tree Source (post include) 36 #address-cells = <2>; 37 #size-cells = <1>; 38 compatible = "fsl,mpc8544-lbc", "fsl,pq3-localbus", "simple-bus"; 44 compatible = "fsl,mpc8540-pci"; 47 bus-range = <0 0xff>; 48 #interrupt-cell [all...] |
/freebsd-src/sys/contrib/device-tree/Bindings/powerpc/fsl/ |
H A D | mpic.txt | 14 - compatible 22 - reg 24 Value type: <prop-encoded-array> 29 - interrupt-controller 35 - #interrupt-cells 39 specifiers do not contain the interrupt-type or type-specific 42 - #address-cells 47 - pic-no-reset 53 configuration registers to a sane state-- masked or 60 - big-endian [all …]
|
/freebsd-src/share/misc/ |
H A D | pci_vendors | 5 # Date: 2024-11-25 03:15:02 8 # the PCI ID Project at https://pci-ids.ucw.cz/. 14 # (version 2 or higher) or the 3-clause BSD License. 25 # device device_name <-- single tab 26 # subvendor subdevice subsystem_name <-- two tabs 30 # This is a relabelled RTL-8139 31 8139 AT-250 [all...] |