/freebsd-src/lib/libpmc/pmu-events/arch/arm64/fujitsu/a64fx/ |
H A D | bus.json | 3 … "PublicDescription": "This event counts read transactions from tofu controller to measured CMG.", 6 "BriefDescription": "This event counts read transactions from tofu controller to measured CMG." 9 "PublicDescription": "This event counts read transactions from PCI controller to measured CMG.", 12 "BriefDescription": "This event counts read transactions from PCI controller to measured CMG." 15 …icDescription": "This event counts read transactions from measured CMG local memory to measured CM… 18 …efDescription": "This event counts read transactions from measured CMG local memory to measured CM… 21 …licDescription": "This event counts write transactions from measured CMG to CMG0, if measured CMG … 24 …iefDescription": "This event counts write transactions from measured CMG to CMG0, if measured CMG … 27 …licDescription": "This event counts write transactions from measured CMG to CMG1, if measured CMG … 30 …iefDescription": "This event counts write transactions from measured CMG to CMG1, if measured CMG … [all …]
|
/freebsd-src/sys/net/ |
H A D | sff8436.h | 76 SFF_8436_TEMP = 22, /* Internally measured module temp */ 81 SFF_8436_RX_CH1_MSB = 34, /* Internally measured RX input power */ 83 SFF_8436_RX_CH2_MSB = 36, /* Internally measured RX input power */ 85 SFF_8436_RX_CH3_MSB = 38, /* Internally measured RX input power */ 87 SFF_8436_RX_CH4_MSB = 40, /* Internally measured RX input power */ 89 SFF_8436_TX_CH1_MSB = 42, /* Internally measured TX bias */ 91 SFF_8436_TX_CH2_MSB = 44, /* Internally measured TX bias */ 93 SFF_8436_TX_CH3_MSB = 46, /* Internally measured TX bias */ 95 SFF_8436_TX_CH4_MSB = 48, /* Internally measured TX bias */
|
/freebsd-src/sys/contrib/device-tree/Bindings/iio/temperature/ |
H A D | melexis,mlx90632.yaml | 17 measured object temperature is in range between -20 to 200 degrees 27 Since measured object emissivity effects Infra Red energy emitted, 33 measured object temperature is in range between -20 to 100 degrees 40 Since measured object emissivity effects Infra Red energy emitted,
|
H A D | mlx90632.txt | 6 and MLX90632 is most suitable for consumer applications where measured object 16 Since measured object emissivity effects Infra Red energy emitted, emissivity
|
/freebsd-src/sys/contrib/dev/iwlwifi/fw/api/ |
H A D | phy.h | 146 * @temp: the measured temperature 147 * @voltage: the measured voltage 157 * @temp: the measured temperature 158 * @voltage: the measured voltage 170 * @temp: the measured temperature
|
H A D | location.h | 1456 * @rtt_variance: The Variance of the RTT values measured for current AP 1458 * values measured for current AP in the current session [pSec] 1461 * measured for current AP in the current session 1465 * @range: Measured range [cm] 1466 * @range_variance: Measured range variance [cm] 1505 * @rtt_variance: The Variance of the RTT values measured for current AP 1507 * values measured for current AP in the current session [pSec] 1510 * measured for current AP in the current session 1558 * @rtt_variance: The Variance of the RTT values measured for current AP 1560 * values measured fo [all...] |
/freebsd-src/sys/contrib/device-tree/src/arm/rockchip/ |
H A D | rk3288-veyron.dtsi | 188 i2c-scl-falling-time-ns = <50>; /* 2.5ns measured */ 189 i2c-scl-rising-time-ns = <100>; /* 45ns measured */ 324 i2c-scl-falling-time-ns = <50>; /* 2.5ns measured */ 325 i2c-scl-rising-time-ns = <100>; /* 40ns measured */ 339 i2c-scl-falling-time-ns = <50>; /* 10ns measured */ 340 i2c-scl-rising-time-ns = <800>; /* 600ns measured */ 347 i2c-scl-falling-time-ns = <50>; /* 11ns measured */ 348 i2c-scl-rising-time-ns = <300>; /* 225ns measured */
|
/freebsd-src/sys/netinet/khelp/ |
H A D | h_ertt.h | 68 /* Per-packet measured RTT. */ 70 /* Maximum RTT measured. */ 72 /* Minimum RTT measured. */
|
/freebsd-src/sys/contrib/device-tree/Bindings/iio/adc/ |
H A D | maxim,max9611.yaml | 28 RS- inputs, across which the current is measured. Value needed to compute 29 the scaling of the measured current.
|
/freebsd-src/sys/contrib/device-tree/Bindings/sound/ |
H A D | maxim,max98390.yaml | 21 description: The calculated temperature data was measured while doing the calibration. 27 description: This is r0 calibration data which was measured in factory mode.
|
H A D | rt1011.txt | 26 u32. The temperature was measured while doing the calibration. Units: Celsius degree 29 u32. This is r0 calibration data which was measured in factory mode.
|
/freebsd-src/sys/contrib/device-tree/Bindings/hwmon/ |
H A D | ntc-thermistor.yaml | 33 |/| Thermistor | Measured voltage (mv) 40 | | Pull-down resistor | Measured voltage (mv) 60 the figure illustrates where the voltage will be measured for the "connected
|
/freebsd-src/sys/contrib/device-tree/Bindings/iio/proximity/ |
H A D | parallax-ping.yaml | 34 length of the input signal corresponds to the measured distance. 36 the time between two interrupts is measured in the driver.
|
/freebsd-src/share/man/man4/ |
H A D | ng_car.4 | 110 By default, all information rates are measured in bits per second and bursts 111 are measured in bytes. 113 rates are measured in packets per second and bursts are in packets.
|
H A D | multicast.4 | 740 * measured bandwidth is above or below a threshold. 786 struct bw_data bu_measured; /* the measured bw */ 816 SEND_UPCALL("measured bandwidth is >= threshold"); 823 SEND_UPCALL("measured bandwidth is <= threshold"); 832 Basically, an upcall is delivered if the measured bandwidth is >= or 913 indicate the particular measured values. 915 the particular intervals are measured, the user should be careful how 923 first one, because the measured interval for >= filters is
|
H A D | cc_vegas.4 | 48 where RTT is the measured instantaneous round trip time and RTTmin is the 69 acknowledgement for that packet is measured once per RTT.
|
/freebsd-src/share/doc/smm/05.fastfs/ |
H A D | 4.t | 50 Table 2 summarizes the measured throughput of the new file system. 75 a month before being measured. 86 File System Bus Measured Speed Bandwidth % CPU 101 File System Bus Measured Speed Bandwidth % CPU
|
/freebsd-src/lib/libc/gmon/ |
H A D | moncontrol.3 | 69 This feature allows the cost of particular operations to be measured. 95 have their execution time measured.
|
/freebsd-src/lib/libsys/ |
H A D | ntp_adjtime.2 | 200 PPS jitter measured by the time median filter in microseconds 206 PPS stability (scaled ppm); dispersion (wander) measured by the 209 Number of seconds that have been discarded because the jitter measured
|
/freebsd-src/usr.bin/netstat/ |
H A D | mroute.c | 88 xo_emit(" {T:/%-30s}", "Measured(Start|Packets|Bytes)"); in print_bw_meter() 98 /* The measured values */ in print_bw_meter() 102 xo_emit("{e:measured-packets/%ju}", in print_bw_meter() 109 xo_emit("{e:measured-bytes/%ju}", in print_bw_meter() 113 xo_emit(" {[:-30}{:start-time/%lu.%06lu}|{q:measured-packets/%s}" in print_bw_meter() 114 "|{q:measured-bytes%s}{]:}", in print_bw_meter()
|
/freebsd-src/share/doc/psd/04.uprog/ |
H A D | p9 | 534 is 0, the offset is measured from the beginning of the file; 537 is 1, the offset is measured from the current read or 541 is 2, the offset is measured from the end of the file. 556 The byte offset, measured from the beginning of the file,
|
/freebsd-src/contrib/llvm-project/llvm/include/llvm/Target/ |
H A D | TargetPfmCounters.td | 17 // measured value is the sum of events on these counters. 32 // event that can be measured using performance counters that is interesting
|
/freebsd-src/share/doc/papers/diskperf/ |
H A D | methodology.ms | 44 In this case, the disk I/O characteristics of VMS were measured 91 measured results.
|
/freebsd-src/sbin/pfctl/ |
H A D | pfctl_qstats.c | 353 printf(" [ measured: %7.1f packets/s, %s/s ]\n", 375 printf(" [ measured: %7.1f packets/s, %s/s ]\n", 395 printf(" [ measured: %7.1f packets/s, %s/s ]\n", 415 printf(" [ measured: %7.1f packets/s, %s/s ]\n", 435 printf(" [ measured: %7.1f packets/s, %s/s ]\n",
|
/freebsd-src/contrib/ntp/html/ |
H A D | stats.html | 26 … reference implementation and how they determine the accuracy and error measured during routine an… 29 …<li>Roundtrip system and network delay measured by the on-wire protocol. This is call <em>roundtri… 33 <p> Figure 1 shows how the various measured statistics are collected and compiled to calibrate NTP … 40 …source is characterized by the offset θ and delay δ samples measured by the on-wire pr…
|