Searched +full:detector +full:- +full:enable (Results 1 – 25 of 47) sorted by relevance
12
1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)3 ---5 $schema: http://devicetree.org/meta-schemas/core.yaml#10 - Antoniu Miclaus <antoniu.miclaus@analog.com>21 - adi,admv101426 spi-max-frequency:32 clock-names:34 - const: lo_in38 vcm-supply:40 Common-mode voltage regulator.[all …]
4 - compatible: Should be one of7 - reg: SPI chip select numbert for the device8 - spi-max-frequency: Max SPI frequency to use (< 20000000)9 - clocks: From common clock binding. Clock is phandle to clock for13 - gpios: GPIO Lock detect - If set with a valid phandle and GPIO number,15 - adi,channel-spacing: Channel spacing in Hz (influences MODULUS).16 - adi,power-up-frequency: If set in Hz the PLL tunes to18 - adi,reference-div-factor: If set the driver skips dynamic calculation20 - adi,reference-doubler-enable: Enables reference doubler.21 - adi,reference-div2-enable: Enables reference divider.[all …]
1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)3 ---5 $schema: http://devicetree.org/meta-schemas/core.yaml#10 - Antoniu Miclaus <antoniu.miclaus@analog.com>21 - adi,admv101326 spi-max-frequency:34 clock-names:36 - const: lo_in38 vcm-supply:42 vcc-drv-supply:[all …]
1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)3 ---5 $schema: http://devicetree.org/meta-schemas/core.yaml#10 - Michae[all...]
1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)3 ---5 $schema: http://devicetree.org/meta-schema[all...]
1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)3 ---5 $schema: http://devicetree.org/meta-schemas/core.yaml#10 - Antoniu Miclaus <antoniu.miclaus@analog.com>21 - adi,adrf678026 spi-max-frequency:34 clock-names:36 - const: lo_in38 clock-output-names:41 adi,vga-buff-en:[all …]
1 // SPDX-License-Identifier: ISC143 mt76x02_dfs_set_capture_mode_ctrl(struct mt76x02_dev *dev, u8 enable) in mt76x02_dfs_set_capture_mode_ctrl() argument147 data = (1 << 1) | enable; in mt76x02_dfs_set_capture_mode_ctrl()154 struct mt76x02_dfs_pattern_detector *dfs_pd = &dev->dfs_pd; in mt76x02_dfs_seq_pool_put()156 list_add(&seq->head, &dfs_pd->seq_pool); in mt76x02_dfs_seq_pool_put()158 dfs_pd->seq_stats.seq_pool_len++; in mt76x02_dfs_seq_pool_put()159 dfs_pd->seq_stats.seq_len--; in mt76x02_dfs_seq_pool_put()165 struct mt76x02_dfs_pattern_detector *dfs_pd = &dev->dfs_pd; in mt76x02_dfs_seq_pool_get()168 if (list_empty(&dfs_pd->seq_pool)) { in mt76x02_dfs_seq_pool_get()169 seq = devm_kzalloc(dev->mt76.dev, sizeof(*seq), GFP_ATOMIC); in mt76x02_dfs_seq_pool_get()[all …]
1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)3 ---5 $schema: http://devicetree.org/meta-schemas/core.yaml#7 title: AMS/TAOS Ambient Light Sensor (ALS) and Proximity Detector10 - Brian Masney <masneyb@onstation.org>14 https://ams.com/documents/20143/36005/TSL2772_DS000181_2-00.pdf19 - amstaos,tsl257120 - amstaos,tsl267121 - amstaos,tmd267122 - amstaos,tsl2771[all …]
9 found at http://www.gnu.org/licenses/gpl-2.0.html132 /* Bit-wise write enable */139 * 0x1 – Select inter-macro reference clock from the left side141 * 0x3 – Select inter-macro reference clock from the right side156 * 0x2 – Select inter-macro reference clock input from right side172 * 0x2 – Select inter-macro reference clock input from left side186 * Program memory acknowledge - Only when the access193 * Data memory acknowledge - Only when the access200 * 0 - keep cpu clk as sb clk205 * 0x0 – OIF CEI-28G-SR[all …]
1 /*-10 found at http://www.gnu.org/licenses/gpl-2.0.html48 * 0 - Hard reset is asserted49 * 1 - Hard reset is de-asserted58 * 0 - Hard reset is taken from the interface pins59 * 1 - Hard reset is taken from registers121 * PMA serial RX-to-TX loop-back enable (from AGC to IO Driver). Serial receive122 * to transmit loopback: 0 - Disables loopback 1 - Transmits the untimed,129 * PMA TX-to-RX buffered serial loop-back enable (bypasses IO Driver). Serial130 * transmit to receive buffered loopback: 0 - Disables loopback 1 - Loops back[all …]
9 found at http://www.gnu.org/licenses/gpl-2.0.html47 * 0 - Hard reset is asserted48 * 1 - Hard reset is de-asserted57 * 0 - Hard reset is taken from the interface pins58 * 1 - Hard reset is taken from registers120 * PMA serial RX-to-TX loop-back enable (from AGC to IO Driver). Serial receive121 * to transmit loopback: 0 - Disables loopback 1 - Transmits the untimed,128 * PMA TX-to-RX buffered serial loop-back enable (bypasses IO Driver). Serial129 * transmit to receive buffered loopback: 0 - Disables loopback 1 - Loops back136 * PMA TX-to-RX I/O serial loop-back enable (loop back done directly from TX to[all …]
1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)3 ---5 $schema: http://devicetree.org/meta-schemas/core.yaml#10 - Cosmin Tanislav <cosmin.tanislav@analog.com>13 The AD74115H is a single-channel software configurable input/output16 temperature detector, and thermocouple measurements integrated into a single17 chip solution with an SPI interface. The device features a 16-bit ADC and a18 14-bit DAC.25 - adi,ad74115h30 spi-max-frequency:[all …]
1 /*-2 * SPDX-License-Identifier: ISC4 * Copyright (c) 2002-2009 Sam Leffler, Errno Consulting5 * Copyright (c) 2002-2008 Atheros Communications, Inc.33 (AH_PRIVATE(_ah)->ah_eeversion & AR5416_EEP_VER_MINOR_MASK)122 HALASSERT(AH_PRIVATE(ah)->ah_eeversion >= AR_EEPROM_VER14_1); in ar5416Reset()144 * Don't do this for the AR9285 - it breaks RX for single in ar5416Reset()173 (ah->ah_config.ah_force_full_reset)) in ar5416Reset()192 AH5416(ah)->ah_writeIni(ah, chan); in ar5416Reset()195 /* Enable ASYNC FIFO */ in ar5416Reset()[all …]
1 .\"-36 .Pa GENERIC-KMSAN37 kernel configuration can be used to compile a KMSAN-enabled kernel using42 .Bd -ragged -offset indent73 runtime component and use hidden, byte-granular shadow state to determine94 In addition to compiler-detected uses of uninitialized memory,110 It is not recommended to enable114 The sanitizer in a KMSAN-configured kernel can be disabled by setting the loader139 mark device-written memory as initialized.161 function and its sub-typed siblings validate the shadow state of the region(s)[all …]
1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)16 #include <dt-bindings/input/gpio-keys.h>17 #include <dt-bindings/input/input.h>18 #include <dt-bindings/leds/common.h>20 #include "sc7280-qcard.dtsi"21 #include "sc7280-chrome-commo[all...]
1 // SPDX-License-Identifier: BSD-3-Clause6 /dts-v1/;12 #include <dt-bindings/iio/qcom,spmi-adc7-pm7325.h>13 #include <dt-bindings/iio/qcom,spmi-adc[all...]
1 // SPDX-License-Identifier: BSD-3-Clause8 #include <dt-bindings/iio/qcom,spmi-adc7-pmk8350.h>9 #include <dt-bindings/input/linux-event-code[all...]
1 <!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.01 Transitional//EN">4 <meta http-equiv="content-type" content="text/html;charset=iso-8859-1">13 <!-- #BeginDate format:En2m -->17-Jul-2014 02:17<!-- #EndDate -->22 …-Range Instrumentation Group (IRIG) standard time distribution signal. This signal is generated by…23 <p>The driver requires an audio codec or sound card with sampling rate 8 kHz and μ-law compandin…24 …d 50 Ohms. In such cases the cable should be terminated at the line-in port with a 50-Ohm resistor…25 … to the PPS signal from a GPS receiver, the mean offset with a 2.4-GHz P4 running FreeBS…26 …. The Sun kernel driver has a sawtooth modulation with amplitude over 5 ms P-P and period 5.5 s. T…30 …-modulated carrier with pulse-width modulated data bits. For IRIG-B, the carrier frequency is 1000…31 …-Hz μ-law companded samples using separate signal filters for IRIG-B and IRIG-E, a comb filter,…[all …]
1 // SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)2 #include <dt-bindings/input/input.h>3 #include <dt-bindings/gpio/gpio.h>4 #include <dt-bindings/leds/common.h>5 #include <dt-bindings/pinctrl/qcom,pmic-gpio.h>6 #include <dt-bindings/pinctrl/qcom,pmic-mpp.h>7 #include "qcom-msm8660.dtsi"12 compatible = "qcom,apq8060-dragonboard", "qcom,msm8660";19 stdout-path = "serial0:115200n8";23 vph: regulator-fixed {[all …]
48 #define INIT_RSSI_BEACON_WEIGHT 8 /* ave beacon rssi weight (0-16) */51 * Various fifo fill before Tx start, in 64-byte units55 #define MAX_TX_FIFO_THRESHOLD (( 4096 / 64) - 1)151 * Per-channel ANI state private to the driver.178 u_int32_t cycle_count; /* Last cycle_count (can detect wrap-around) */195 ((AH9300(ah)->ah_proc_phy_err & HAL_PROCESS_ANI))211 u_int32_t ast_ani_reset; /* ANI parameters zero'd for non-STA */317 (iniarray)->ia_array = (const u_int32_t *)(array); \318 (iniarray)->ia_rows = (rows); \319 (iniarray)->ia_columns = (columns); \[all …]
1 //===-- tsan_interface_ann.cpp --------223 AnnotateEnableRaceDetection(char * f,int l,int enable) AnnotateEnableRaceDetection() argument [all...]
3 …y executing divide or square root operations. Accounts for integer and floating-point operations.",415 …e number of prefixes in a 16B-line. This may result in a three-cycle penalty for each LCP (Length …434 …tion. For instructions that consist of multiple micro-ops, Counts the retirement of the last micro…439 "BriefDescription": "Number of instructions retired. General Counter - architectural event",445 …n": "Counts the number of instructions (EOMs) retired. Counting covers macro-fused instructions in…486 …"BriefDescription": "Cycles the issue-stage is waiting for front-end to fetch from resteered path …550 …"PublicDescription": "Counts all not software-prefetch load dispatches that hit the fill buffer (F…561 …blicDescription": "Counts the cycles when 4 uops are delivered by the LSD (Loop-stream detector).",572 …iption": "Counts the cycles when at least one uop is delivered by the LSD (Loop-stream detector).",582 … "PublicDescription": "Number of uops delivered to the back-end by the LSD(Loop Stream Detector).",[all …]
1 //===-- llvm/Support/Compiler.h - Compiler abstraction support --*- C++ -*-===//5 // SPDX-License-Identifie[all...]