| /freebsd-src/sys/dev/usb/controller/ |
| H A D | xlnx_dwc3.c | 107 device_printf(dev, "Cannot deassert reset\n"); in xlnx_dwc3_attach()
113 device_printf(dev, "Cannot deassert reset\n"); in xlnx_dwc3_attach()
119 device_printf(dev, "Cannot deassert reset\n"); in xlnx_dwc3_attach()
|
| /freebsd-src/sys/contrib/device-tree/src/arm/st/ |
| H A D | stm32mp151a-prtt1c.dts | 114 reset-deassert-us = <35>;
124 reset-deassert-us = <35>;
135 reset-deassert-us = <35>;
145 reset-deassert-us = <1000>;
|
| H A D | stm32mp151a-prtt1a.dts | 27 reset-deassert-us = <35>;
|
| H A D | stm32mp151a-prtt1s.dts | 57 reset-deassert-us = <35>;
|
| /freebsd-src/sys/riscv/sifive/ |
| H A D | fu740_pci_dw.c | 218 /* Deassert core power-on reset (active low) */ in fupci_phy_init()
221 device_printf(dev, "Cannot deassert power-on reset: %d\n", in fupci_phy_init()
236 /* Deassert the aux reset */ in fupci_phy_init()
239 device_printf(dev, "Cannot deassert aux reset: %d\n", error); in fupci_phy_init()
280 /* Deassert PERST_N */ in fupci_phy_init()
|
| /freebsd-src/sys/contrib/device-tree/Bindings/net/ |
| H A D | mdio.yaml | 44 Delay after reset deassert in microseconds. It applies to all MDIO
89 reset-deassert-us:
|
| H A D | ethernet-phy.yaml | 192 reset-deassert-us:
266 reset-deassert-us = <2000>;
|
| /freebsd-src/sys/contrib/device-tree/Bindings/reset/ |
| H A D | ti-syscon-reset.txt | 37 Cell #3 : offset of the reset deassert control
40 deassert control register
|
| H A D | st,stih407-picophyreset.yaml | 19 registers and after an assert/deassert sequence the hardware's previous state
|
| H A D | st,stih407-powerdown.yaml | 21 registers and after an assert/deassert sequence the hardware's previous state
|
| H A D | hisilicon,hi3660-reset.yaml | 41 offset + 4: deassert control register
|
| H A D | st,sti-picophyreset.txt | 10 registers and after an assert/deassert sequence the hardware's previous state
|
| H A D | st,sti-powerdown.txt | 12 registers and after an assert/deassert sequence the hardware's previous state
|
| H A D | hisilicon,hi3660-reset.txt | 20 offset + 4: deassert control register
|
| H A D | st,sti-softreset.txt | 11 registers and after an assert/deassert sequence the hardware's previous state
|
| H A D | img,pistachio-reset.txt | 10 registers, and following an assert/deassert sequence the hardware's previous
|
| /freebsd-src/sys/contrib/dev/athk/ath10k/ |
| H A D | ahb.c | 252 ath10k_err(ar, "failed to deassert radio cold rst: %d\n", ret); in ath10k_ahb_release_reset()
258 ath10k_err(ar, "failed to deassert radio warm rst: %d\n", ret); in ath10k_ahb_release_reset()
264 ath10k_err(ar, "failed to deassert radio srif rst: %d\n", ret); in ath10k_ahb_release_reset()
270 ath10k_err(ar, "failed to deassert cpu init rst: %d\n", ret); in ath10k_ahb_release_reset()
385 ath10k_err(ar, "failed to deassert core cold rst: %d\n", ret); in ath10k_ahb_halt_chip()
|
| /freebsd-src/sys/arm64/rockchip/ |
| H A D | rk_pcie.c | 858 /* Deassert basic resets*/ in rk_pcie_enable_resources()
861 device_printf(sc->dev, "Cannot deassert 'pm' reset\n"); in rk_pcie_enable_resources()
866 device_printf(sc->dev, "Cannot deassert 'aclk' reset\n"); in rk_pcie_enable_resources()
871 device_printf(sc->dev, "Cannot deassert 'pclk' reset\n"); in rk_pcie_enable_resources()
892 /* Deassert rest of resets - order is important ! */ in rk_pcie_enable_resources()
895 device_printf(sc->dev, "Cannot deassert 'mgmt_sticky' reset\n"); in rk_pcie_enable_resources()
900 device_printf(sc->dev, "Cannot deassert 'core' reset\n"); in rk_pcie_enable_resources()
905 device_printf(sc->dev, "Cannot deassert 'mgmt' reset\n"); in rk_pcie_enable_resources()
910 device_printf(sc->dev, "Cannot deassert 'pipe' reset\n"); in rk_pcie_enable_resources()
953 /* Deassert PERS in rk_pcie_setup_hw()
[all...] |
| /freebsd-src/sys/contrib/device-tree/src/arm/nxp/imx/ |
| H A D | imx6qp-prtwd3.dts | 70 reset-deassert-us = <1000>;
82 reset-deassert-us = <2000>;
235 reset-deassert-us = <1000>;
|
| /freebsd-src/sys/contrib/alpine-hal/ |
| H A D | al_hal_pcie_interrupts.h | 52 * 2. INTA assert/deassert (RC only).
85 * line that reflects the status of ASSERT/DEASSERT of INTA
96 * line that reflects the status of ASSERT/DEASSERT of INTA
|
| /freebsd-src/sys/arm/qualcomm/ |
| H A D | ipq4018_usb_hs_phy.c | 90 * For power-on - power off first, then deassert srif, then in ipq4018_usb_hs_phynode_phy_enable()
91 * sleep for 10ms, then deassert por. in ipq4018_usb_hs_phynode_phy_enable()
|
| /freebsd-src/sys/contrib/device-tree/src/arm64/rockchip/ |
| H A D | rk3328-nanopi-r2c.dts | 36 reset-deassert-us = <50000>;
|
| H A D | rk3328-orangepi-r1-plus-lts.dts | 38 reset-deassert-us = <50000>;
|
| /freebsd-src/sys/contrib/device-tree/Bindings/gpio/ |
| H A D | realtek,rtd-gpio.yaml | 38 - description: Interrupt number of the deassert GPIO interrupt, which is
|
| /freebsd-src/sys/dev/hwreset/ |
| H A D | hwreset_if.m | 56 # Assert/deassert given reset.
|