Lines Matching full:terminal

41 .Nd set the options for a terminal device interface
50 utility sets or reports on terminal
56 the terminal state according to the specified arguments.
58 exclusive on some terminal types.
63 Display all the current settings for the terminal to standard output.
65 Display all the current settings for the terminal to standard output
73 Open and use the terminal named by
81 set or display settings on a terminal that might otherwise
84 Display all the current settings for the terminal to standard output
87 to restore the current terminal state.
92 The following arguments are available to set the terminal
96 terminal.
109 Set terminal baud rate to the
116 Set terminal input baud rate to the
124 Set terminal output baud rate to
230 character to the output queue (the terminal beeps at you).
265 Local mode flags (lflags) affect various and sundry characteristics of terminal
350 terminal output.
440 Set the current terminal
480 Resets all modes to reasonable values for interactive terminal use.
482 Set the line discipline to the standard terminal line discipline
497 The terminal size is recorded as having
504 The terminal size is recorded as having
519 If set, this flag indicates that some amount of terminal processing is being
520 performed by either the terminal hardware or by the remote side connected
523 If set, change the modes of the terminal so that no input or output processing
525 If unset, change the modes of the terminal to some reasonable
527 Note that since the terminal driver no longer has a single
534 To set the terminal into a raw state and then accurately restore it,
543 The size of the terminal is printed as two numbers on a single line,
551 Reports all the terminal modes as with