Lines Matching full:tuning
158 /* Hardware tuning can fail, fallback to SW tuning in that case. */
162 * Check window and perform SW tuning.
178 * HS400 tuning is done in HS200 mode, but it has to be done using
180 * know the target mode during tuning procedure. Use this flag for just that.
1183 "Failed to execute generic tune while performing software tuning.\n");
1206 * For tuning mode SD clock divider must be within 3 to 16.
1241 * Set TBCTL[TB_EN] register and program valid tuning mode.
1243 * "eSDHC takes care of the re-tuning during data transfer
1244 * (auto re-tuning).".
1245 * Tuning mode can only be changed while the clock is disabled.
1262 /* Perform hardware tuning. */
1272 * declare that the tuning was successful. Verify the tuning window to
1281 /* If hardware tuning failed, try software tuning. */
1289 device_printf(bus, "Software tuning failed.\n");
1322 * Only re-tuning with full reset is supported.
1324 * periodic re-tuning is done automatically. See comment in
1326 * Because of that re-tuning should only be triggered as a result