Lines Matching +full:bt +full:- +full:pcm +full:- +full:int +full:- +full:params
2 ---------------------
12 - compatible: should contain one of the following:
14 * "brcm,bcm4329-bt"
15 * "brcm,bcm4330-bt"
16 * "brcm,bcm43438-bt"
18 * "brcm,bcm43540-bt"
23 - max-speed: see Documentation/devicetree/bindings/serial/serial.yaml
24 - shutdown-gpios: GPIO specifier, used to enable the BT module
25 - device-wakeup-gpios: GPIO specifier, used to wakeup the controller
26 - host-wakeup-gpios: GPIO specifier, used to wakeup the host processor.
28 "host-wakeup" interrupt-names
29 - clocks: 1 or 2 clocks as defined in clock-names below, in that order
30 - clock-names: names for clock inputs, matching the clocks given
31 - "extclk": deprecated, replaced by "txco"
32 - "txco": external reference clock (not a standalone crystal)
33 - "lpo": external low power 32.768 kHz clock
34 - vbat-supply: phandle to regulator supply for VBAT
35 - vddio-supply: phandle to regulator supply for VDDIO
36 - brcm,bt-pcm-int-params: configure PCM parameters via a 5-byte array
37 - sco-routing: 0 = PCM, 1 = Transport, 2 = Codec, 3 = I2S
38 - pcm-interface-rate: 128KBps, 256KBps, 512KBps, 1024KBps, 2048KBps
39 - pcm-frame-type: short, long
40 - pcm-sync-mode: slave, master
41 - pcm-clock-mode: slave, master
42 - interrupts: must be one, used to wakeup the host processor
43 - interrupt-names: must be "host-wakeup"
48 pinctrl-names = "default";
49 pinctrl-0 = <&uart2_pins>;
52 compatible = "brcm,bcm43438-bt";
53 max-speed = <921600>;
54 brcm,bt-pcm-int-params = [01 02 00 01 01];