Lines Matching +full:firmware +full:- +full:name

1 .\" Copyright (c) 2009-2020 Alexander Motin <mav@FreeBSD.org>
3 .\" Copyright (c) 1998-2001 Matthew Jacob, for NASA/Ames Research Center
13 .\" 3. The name of the author may not be used to endorse or promote products
30 .Sh NAME
37 .Bd -ragged -offset indent
46 .Bd -literal -offset indent
57 Support is available for Public and Private loops, Point-to-Point
60 Supported FC-Tape functionality is highly recommended for connections
62 It encompasses four elements from the T-10 FCP-4 specification:
63 .Bl -bullet -offset indent
79 FC-Tape is automatically enabled when connecting controller that supports
82 .Sh FIRMWARE
83 Firmware loading is supported and handled by
84 .Xr firmware 9 .
85 The correct firmware is either loaded automatically, if available for this
89 It is strongly recommended that you use the firmware available from
96 .Bl -tag -width xxxxxx -offset indent
98 Optical 4Gb Fibre Channel PCI-X cards.
125 To disable FC-Tape, use the following configuration option:
136 .Bl -tag -width indent
140 Limit on number of Extended Message Signaled Interrupts (MSI-X) to be used.
142 A hint value to disable loading of firmware provided by
145 A hint value to prefer firmware provided by
147 even if it is older than the firmware in flash on the board.
153 firmware.
156 driver will use the firmware provided by
158 if it is available, and otherwise use the firmware in flash on the board.
168 .Bl -tag -width ".Li lport-only" -compact
173 .It Li lport-only
175 .It Li nport-only
179 This should be the full 64 bit World Wide Port Name you would like
182 This should be the full 64 bit World Wide Node Name you would like
189 recommended that you set this value to non-zero.
191 A hint to define default role for isp instance (0 -- none, 1 -- target,
192 2 -- initiator, 3 -- both).
200 Set this to 1 to disable FC-Tape operation on the given isp instance.
202 Set this to 1 to enable FC-Tape operation on the given isp instance for
206 .Bl -tag -width indent
228 This is the readonly World Wide Node Name value for this port.
230 This is the readonly World Wide Port Name value for this port.
232 The readonly flash firmware version value in the active region of the
235 The readonly firmware version value provided by
238 The readonly firmware version value currently executed on the controller.