Lines Matching full:statement

87 statement determines the amount of time that must pass between the
101 statement determines the time that must pass after the client has
134 statement sets the time that must elapse after the client first tries
144 statement determines the maximum amount of time that the client is
150 statement sets the amount of time between the first attempt to reach a
178 statement causes the client to request that any server responding to the
180 Only the option names should be specified in the request statement - not
185 statement lists options that must be sent in order for an offer to be accepted.
190 statement causes the client to send the specified options to the server with
198 The other obvious use for this statement is to send information to the server
204 statement causes the client to disregard the specified options in any offer
223 statement.
232 statement.
249 statement.
252 statement can only be used for options which allow more than one value to
263 statement.
266 statement can only be used for options which allow more than one value to
289 statement.
291 NOTE: the lease statement is also used in the
299 A lease statement consists of the
309 statement is used to indicate that the lease was acquired using the
316 lease statement is used to indicate the interface on which the lease is valid.
326 statement is used to set the IP address of a particular lease.
333 statement specifies the name of the boot filename to use.
339 statement specifies the name of the boot server name to use.
344 statement is used to specify the value of an option supplied by the server,
352 statement is used to specify the pathname of the DHCP client configuration
365 statement can be used on systems where network interfaces cannot
383 statement) when configuring the interface in order to obtain a lease.
384 This statement should be used in predefined leases only if the network
391 statement defines the time at which the DHCP client should begin trying to
395 statement defines the time at which the DHCP client should begin to try to
401 statement defines the time at which the DHCP client must stop using a lease
450 A medium statement should never be included in an alias declaration.
456 statement causes the DHCP client to reject offers from servers who use
474 statement defines one or more media configuration parameters which may
493 statement sets the PCP (Priority Code Point) value for the VLAN header.