Lines Matching full:mhz

138 		   "HT40: control channel: %d (%d MHz), secondary channel: %d (%d MHz)",
141 	/* Verify that HT40 secondary channel is an allowed 20 MHz
291 		wpa_printf(MSG_DEBUG, "Found overlapping 20 MHz HT BSS: "
316 	wpa_printf(MSG_DEBUG, "40 MHz affected channel range: [%d,%d] MHz",
324 		/* Check for overlapping 20 MHz BSS */
328 				   "Overlapping 20 MHz BSS is found");
352 					   "40 MHz pri/sec mismatch with BSS "
373 					   "40 MHz Intolerant is set on channel %d in BSS "
449 	/* TODO: 320 MHz */
547 						   "6 GHz 80+80 MHz configuration doesn't use valid 80 MHz channels");
575 				   "320 MHz channel width is not supported in 5 or 6 GHz");
593 					   "40 MHz channel width is not supported in 2.4 GHz");
605 					   "40/80 MHz channel width is not supported in 5/6 GHz");
615 				   "80+80 MHz channel width is not supported in 5/6 GHz");
624 				   "160 MHz channel width is not supported in 5 / 6GHz");
646 				   "160 MHz channel width is not supported!");
670 				   "20/40 MHz: center segment 0 (=%d) and center freq 1 (=%d) not in sync",
679 				   "80+80 MHz: center segment 1 only 20 MHz apart");
689 				   "80/80+80 MHz: no second channel offset");
695 				   "80 MHz: center segment 1 configured");
701 				   "80+80 MHz: center segment 1 not configured");
742 				   "160 MHz: center segment 1 should not be set");
748 				   "160 MHz: second channel offset not set");
766 				   "160 MHz: HT40 channel band is not in 160 MHz band");
774 				   "320 MHz: EHT not enabled or not a 6 GHz channel");
779 				   "320 MHz: center segment 1 should not be set");
801 				   "320 MHz: wrong center segment 0");
936 		/* HT 40 MHz support declared only for primary channel,
937 		 * just skip 40 MHz secondary checking */