Lines Matching +full:clock +full:- +full:accuracy
1 <!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.01 Transitional//EN">
4 <meta http-equiv="content-type" content="text/html;charset=iso-8859-1">
13 <!-- #BeginDate format:En2m -->17-Jul-2014 02:17<!-- #EndDate -->
22 …-Range Instrumentation Group (IRIG) standard time distribution signal. This signal is generated by…
23 <p>The driver requires an audio codec or sound card with sampling rate 8 kHz and μ-law compandin…
24 …d 50 Ohms. In such cases the cable should be terminated at the line-in port with a 50-Ohm resistor…
25 … to the PPS signal from a GPS receiver, the mean offset with a 2.4-GHz P4 running FreeBS…
26 …accuracy with Solaris 2.8 and beyond has been seriously degraded to the order of several milliseco…
27 …his page. Note that additional checks are done elsewhere in the reference clock interface routines…
28 …okup, debugging and monitoring, see the <a href="../audio.html">Reference Clock Audio Drivers</a> …
30 …-modulated carrier with pulse-width modulated data bits. For IRIG-B, the carrier frequency is 1000…
31 …-Hz μ-law companded samples using separate signal filters for IRIG-B and IRIG-E, a comb filter,…
32 …o the corrected slice level determine the width of each pulse and its value - zero, one or positio…
33 …-II phase-lock loop (PLL) performs additional integration and interpolation to accurately determin…
38 …-3000), codec gain (0-255), modulation index (0-1), time constant (4-10), carrier phase error (0&p…
71 …<dd>Specifies the microphone port if set to zero or the line-in port if set to one. It does not se…