Lines Matching +full:write +full:- +full:0 +full:- +full:bps
1 <!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.01 Transitional//EN">
4 <meta http-equiv="content-type" content="text/html;charset=iso-8859-1">
11 <img src="pic/radio2.jpg" alt="jpg" align="left">ICOM R-72 shortwave receiver and Sure audio mixer
13 <!-- #BeginDate format:En2m -->11-Sep-2010 05:55<!-- #EndDate -->
31 and decoding techniques, including maximum-likelihood and soft-decision methods.
32 The documentation page for each driver contains an in-depth discussion on
36 … to cause the AGC to set the gain somewhere in the middle of the range from 0 to 255, as indicated…
38 …e flag 2</tt> command selects the microphone port if set to zero or the line-in port if set to one…
40 …l shortwave radio with the radio output - speaker or headphone jack - connected to either the micr…
41 …- even 15 feet is enough if it is located outside of a metal frame building, preferably on the roo…
42 … house wiring, which can also be used to power the radio. A couple of center-tapped audio transfor…
43 …our. While both drivers support the ICOM CI-V radio interface and can tune the radio automatically…
44 <p>Shortwave (3-30 MHz) radio propagation phenomena are well known to shortwave enthusiasts. The ph…
52 …<li>The optimum frequencies are higher at the peak of the 11-year sunspot cycle and lower at the t…
56 …-V interface. Since all ICOM select codes are less than 128, the high order bit of the code is use…
68 <td>0x4e</td>
71 <td>0x46</td>
76 <td>0x58</td>
79 <td>0x26</td>
84 <td>0x28</td>
87 <td>0x2e</td>
92 <td>0x30</td>
95 <td>0x70</td>
100 <td>0x04</td>
103 <td>0x1A</td>
108 <td>0x66</td>
111 <td>0x32</td>
116 <td>0x1c</td>
119 <td>0x5a</td>
124 <td>0x64</td>
127 <td>0x08</td>
132 <td>0x1e</td>
135 <td>0x34</td>
140 <td>0x2c</td>
143 <td>0x4a</td>
151 <td>0x2a</td>
160 radios have recorder outputs which produce a microphone-level signal not affected
163 headphone or speaker output to the line-in port and adjust the volume control
165 level somewhere in the middle of the range 0-255. IRIG signals are usually
167 may even overload the line-in port. In such cases the signal is designed to
168 drive a cable terminated with a 50-ohm resistor, which results in a level
169 the line-in port can handle..</p>
176 …write a synthesized timecode to the <tt>clockstats</tt> file each time the clock is set or verifie…